Jump to content
  • GUESTS

    If you want access to members only forums on HSO, you will gain access only when you Sign-in or Sign-Up .

    This box will disappear once you are signed in as a member. ?

10 inch bullheads


Scott K

Recommended Posts

In response to SteveD's #1 scenario, the use of 7" + bullies. Lets say I catch a bunch of them in the MN river but then transport them back to a holding tank at the house. When I go fishing on the MN river I then grab the bait from the holding tank for use as live bait that night. It that legal? I'm guessing it would be.

Link to comment
Share on other sites

  • Replies 217
  • Created
  • Last Reply

Top Posters In This Topic

In response to SteveD's #1 scenario, the use of 7" + bullies. Lets say I catch a bunch of them in the MN river but then transport them back to a holding tank at the house. When I go fishing on the MN river I then grab the bait from the holding tank for use as live bait that night. It that legal? I'm guessing it would be.

Nope, it is not legal. At least not right now is isn't. If and when the 10 inch bullhead rule is implemented then it should be. But for right now, it's not. This is directly from the 2010 Minnesota Fishing Regulations, Page 10:

Transporting Fish

• Except while on the body of water where taken, live fish may not be

transported in a quantity of water sufficient to keep them alive unless the fish

are bait minnows or the person is authorized to do so by the DNR.

This is taken from page 15, Stop Aquatic Hitchhikers!

Drain water from your boat, motor, livewell, and bait containers before leaving

the water access.

Right now 10" bullheads are rough fish and as such it is illegal to transport them. Let's all hope the 10" bullhead rule is implemented - that will clear up this whole issue.

Link to comment
Share on other sites

there is a loop hole Steve but it may not be seen the same way I see this and that is that the bullheads you are transporting are classified as bait (minnows) and therefore leagle to transport.

Its probally not right but it is a interpation of how I read it.

This would be for leagle size bully's for bait now.

Link to comment
Share on other sites

there is a loop hole Steve but it may not be seen the same way I see this and that is that the bullheads you are transporting are classified as bait (minnows) and therefore leagle to transport.

Its probally not right but it is a interpation of how I read it.

This would be for leagle size bully's for bait now.

Yea, you guys caught it. Right now any bullhead over 7" (what I call 7"+) is a rough fish and as such is not legally a minnow. You can legally transport bullheads under 7" because they are minnows.

Link to comment
Share on other sites

The issue was covered in today's Outdoor News with an article. I found one photo interesting; it showed a bullhead on a hook and the hook was inserted near the anal fin pointing backwards. I hadn't seen that before. I'll probably stick with my dorsal, point-forward hooking style.

Link to comment
Share on other sites

Here's the latest, courtesy of Brian K:

Bob Meier Asst. Commissioner, Policy & Government Relations for the MN DNR, told the President of MOHA that the Bullhead Lenght Law will be written into this sessions Game and Fish Bill.

If the bill is approved by the legislature, our 10" change will become law May 15th of this year.

This assumes two things.

1) Mr. Meier gets the language into the bill as he's promised.

2) The bill is passed.

The rule change process is still moving forward. With all the red tape to go through yet, the DNR's time line is August if the Game and Fish Bill fails.

The above is actually paving the way for a more streamlined system for the DNR to change non controversial laws in the future. More on this to come.

Link to comment
Share on other sites

The issue was covered in today's Outdoor News with an article. I found one photo interesting; it showed a bullhead on a hook and the hook was inserted near the anal fin pointing backwards. I hadn't seen that before. I'll probably stick with my dorsal, point-forward hooking style.

Da chise thats how I hook my bullys and as soon as this bill passes I will be hooking the 10 inchers that way wink

Link to comment
Share on other sites

I still have a few bullheads in my tank from last year. I had high hopes to get out fishing a couple more times last fall, then when I finally figured I wasnt going to make it out anymore, there was a good 4 inches of ice on top of my bait tank, and I could get them out. The bullheads were still alive then, and I wished them luck throughout the winter. But when I looked this spring, my good luck wish just wasnt enough to keep them alive grin

I still have a huge 6 foot long 3 foot high, 2 feet wide brick of ice/bullheads in my tank that just doesnt thaw very well. I would think with next weeks weather it should melt down pretty quick.

Link to comment
Share on other sites

Join the conversation

You can post now ↓↓↓ or ask your question and then register. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Your Responses - Share & Have Fun :)

    • As a recovering machinist, I can appreciate that.  If the spec is 0.001 - 0.0015, then clearly the correct measurement is 0.00125, duh…
    • I just figured that it is easy enough to just get a 3 bank so when the boat is not in use I can keep all 3 batteries charged. I have not bough a charger yet, maybe I will give it some more thought. Edit: After thinking this over, with the size, weight, and heat output of the charger (as well as the cost) I think it makes sense to just buy a 2 bank charger, I have a smaller charger i can use on the starting battery when the boat is sitting at home. Forgive me, for i am a retired engineer and I have to obsess over everything...
    • Congrats on the motor!  I think you’ll like it.   I can’t say much on the charger location but I’ve seen them under the lid in back compartments and under center rod lockers.  160 degrees is more than I expected to hear.   Curious why you’re opting for a 3 bank charger with a 24V trolling motor.  Unless you don’t feel you be running you big motor enough to keep that battery up as well?
    • I did buy an Minnkota Ulterra, thanks for the recommendations. I had a bunch of Cabela"s bucks saved up, which helped. Now i need to get an onboard battery charger. Where do you guys mount these things in your boat? The manufacturer I am looking at {Noco genius) says tht their 3-bank charger will run at 160 degrees, seems like a lot of heat in an enclosed compartment? Thanks for any input on this.
    • You're very lucky a troop of Sea Monkey's didn't carry you away.   
    • Wasn't terrible at a state park beach. Antelope island maybe.  I wouldn't recommend it as a beach destination tho.  Figured I was there, I'm getting in it.
    • The water looked and smelled disgusting with hundreds of thousands of birds sh*tting in there.  About as gross as the Salton Sea. When I duck hunted there I didn't even want to touch the water.
    • It's kinda gross with the algae in the summer but I got in it anyway.  Wanted to see the increased bouyancy at work.  You can kinda tuck yourself into a ball and you'll just float with your head above water.  When dry off you look diamond encrusted with the salt.
    • We went to the flats too. I dipped a tire on the rental car onto it just to say I’ve been there,but it was still pretty soft from winter melt. After seeing some moron in a BMW suv get dragged out of the muck I had no intention of repeating his stupidity. 
    • I've been out on the flats. It's like being on a different planet 
  • Topics

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use and Privacy Policy. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.