Jump to content
  • GUESTS

    If you want access to members only forums on HSO, you will gain access only when you Sign-in or Sign-Up .

    This box will disappear once you are signed in as a member. ?

  • 0

where is the howling heater posts?


picksbigwagon

Question

17 answers to this question

Recommended Posts

  • 0

Mine likes to make big flames...and the occasional ear shattering screech.

Half the time i cannot even shut it off without unscrewing the 1# tank.

Them sunflowers light up everytime though grin

Sure makes coffee fast when the flames are higher than the camping coffee pot eek Got to have some good gloves close by when i fire that thing up! Time to buy a new one i think.

Link to comment
Share on other sites

  • 0

I think they operate the same. On startup, to reduce the loud whine, i put a finger or two over the air intake holes. This will increase the flame size until you pull your fingers off the holes. Typically you can warm up the heater faster and avoid the loud whine.

Is yours making the noise after startup?

Link to comment
Share on other sites

  • 0

I looked last night and searched multiple times about the howling heaters and how to fix it, I have two at home and I know the information is located here somewhere

thanks

I cured the squeal in my heater by taping the air breather hole partially closed with a piece of electrical tape that I had with me one time. That is where all of the squealing is coming from.

Have to make sure that you do not close off to much of the hole though. Trial and error thing!

Cliff

Link to comment
Share on other sites

  • 0

Perhaps no one really wants to know as it can be a great topic for discussion in the fish house. Knowledge can certainly take the mystery out of life.

As the air enters the port on the tube connected to the plenum the molecules start to vibrate in an amplified fashion because of a couple factors. These vibrating particles drive sympathetic vibrations of greater magnitude at the same frequency in the plenum. Frequencies at which the response amplitude is at a relative maximum are known as the system's resonant frequencies. The frequency this occurs at depends on the construction of the heater but since they’re all basically the same, the pitch of the sound you hear from one heater to another will all be very similar.

I have one heater tuned to a B flat and use that one for walleye fishing and another tuned to an E for crappies and sunfish.

Link to comment
Share on other sites

Join the conversation

You can post now ↓↓↓ or ask your question and then register. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Answer this question...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use and Privacy Policy. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.