Corners When doing baseboard

[brahambaseball]

I am considering doing some new baseboard in my house, and am wondering about outside corners. I helped my buddy do his last week, and it was a pain cutting, and re cutting outside corners to get them to look good. I was think about using these. Any thoughts? Are they in style anymore? It would make cutting the corners easy, but i'm not sure if they're "in style" anymore...

[crothmeier]

I think they look nice, and are a ton easier than trying to 45 everything.

[sparcebag]

Those are made to match old style base,they can be used with new but they may look abit large in comparison to standard base.

A bit of practice and your outside corners will improve!

[fsnrod]

You have to cut your outside corners over a 45 a few degrees and inside corners are coped with a backcut.

[Pooh]

thats all we use. not the particular style but the same idea. makes it alot easier.

[brahambaseball]

I found this one on H.Depots HSOforum... I was going to stop in there tonight and look at them in person. Any other places to find stuff like this... besides menards?

[hawkeye43]

I think they make outside corners like that. they just have a notch out of one side or you could cut out on a table saw.

[bak2MN]

Those are the only way to go they look clean and will save you a ton of time. If you dont like the height of them you can cut them down a little.