- 0
-
Your Responses - Share & Have Fun :)
-
I haven’t done any leaf springs for a long time and I can’t completely see the connections in your pics BUT I I’d be rounding up: PB Blaster, torch, 3 lb hammer, chisel, cut off tool, breaker bar, Jack stands or blocks. This kind of stuff usually isn’t the easiest. I would think you would be able to get at what you need by keeping the house up with Jack stands and getting the pressure off that suspension, then attack the hardware. But again, I don’t feel like I can see everything going on there. -
reviving an old thread due to running into the same issue with the same year of house. not expecting anything from yetti and I already have replacement parts ordered and on the way. I am looking for some input or feedback on how to replace the leaf springs themselves. If I jack the house up and remove the tire, is it possible to pivot the axel assembly low enough to get to the other end of the leaf spring and remove that one bolt? Or do I have to remove the entire pivot arm to get to it? Then I also have to factor in brake wire as well then. What a mess My house is currently an hour away from my home at a relatives, going to go back up and look it over again and try to figure out a game plan. Above pic is with house lowered on ice, the other end of that leaf is what I need to get to. above pic is side that middle bolt broke and bottom 2 leafs fell out here is other side that didnt break but you can see bottom half of leaf already did but atleast bolt is still in there here is hub assembly in my garage with house lowered and tires off when I put new tires on it a couple months ago. hopefully I can raise house high enough that it can drop down far enough and not snap brake cable there so I can get to that other end of the leaf spring. -
-
-
-
-
Bear can relate too. Tell Leech to start a new account named Leech5, we'll know who he is.If he has any trouble, Bear can walk him through it. -
-
-
-
-
Topics
-
Question
CatManLee
Not sure if anyone can help me or not, but here goes.
I have a Lowrance I-Finder. The 12-Volt Car plug doesn't work too well. It worked alright when I first got it, but soon after started acting a tad goofy. (should have brought it back, but it's a long drive) Anyways, I would have to move it around in the socket to get it to stay on, now I have to push really hard to make it work, and as soon as I let go, the light goes off. I don't have my reciept, packaging or anything, just know I bought it at Cabela's, and I'm fairly positive they are just gonna tell me there's nothing they can do about it, soooo does anyone here know how these things work and what I might do to fix it?
Just so you know it's clean, has only been used a couple of times and I have tryed it in 4 different outlets with the same results.
Link to comment
Share on other sites
6 answers to this question
Recommended Posts