I have an 89 Mariner 25hp tiller but the electric start has gone. It just clicks when I press the starter. No cranking at all. I've been just pulling the cord to get by, but I would like to get this fixed long-term. I am ashamed to say it, but I am not much of a mechanical guy, so I'm looking for a place that will help me out and not charge me an arm and a leg. I'd like to know how much it'll take to fix it, 'cause it may just not be worth it to me. I have no problem pulling the cord if I have to, but I bought an electric start motor, so it should act like one, darnit. Anyway, are there suggestions for reputable places that can help me? (I live in Lakeville, by the way.)
reviving an old thread due to running into the same issue with the same year of house. not expecting anything from yetti and I already have replacement parts ordered and on the way.
I am looking for some input or feedback on how to replace the leaf springs themselves.
If I jack the house up and remove the tire, is it possible to pivot the axel assembly low enough to get to the other end of the leaf spring and remove that one bolt?
Or do I have to remove the entire pivot arm to get to it? Then I also have to factor in brake wire as well then. What a mess
My house is currently an hour away from my home at a relatives, going to go back up and look it over again and try to figure out a game plan.
Above pic is with house lowered on ice, the other end of that leaf is what I need to get to.
above pic is side that middle bolt broke and bottom 2 leafs fell out
here is other side that didnt break but you can see bottom half of leaf already did but atleast bolt is still in there
here is hub assembly in my garage with house lowered and tires off when I put new tires on it a couple months ago. hopefully I can raise house high enough that it can drop down far enough and not snap brake cable there so I can get to that other end of the leaf spring.
Question
bkft
Hi All,
I have an 89 Mariner 25hp tiller but the electric start has gone. It just clicks when I press the starter. No cranking at all. I've been just pulling the cord to get by, but I would like to get this fixed long-term. I am ashamed to say it, but I am not much of a mechanical guy, so I'm looking for a place that will help me out and not charge me an arm and a leg. I'd like to know how much it'll take to fix it, 'cause it may just not be worth it to me. I have no problem pulling the cord if I have to, but I bought an electric start motor, so it should act like one, darnit. Anyway, are there suggestions for reputable places that can help me? (I live in Lakeville, by the way.)
Thanks!
John
Link to comment
Share on other sites
6 answers to this question
Recommended Posts