Currently planning on swapping out my 12 ft flatbottom for a 14ft flat. Would like to keep my trailer if possible. Currently the trailer extends about 2 inches longer than my 12ft. So if I made the switch it would extend close to 2 ft out past the trailer. Would this be okay or would I need to extend out the runners? The only problem I could think is the weight of the motor that much farther back might cause a bit more force causing some point of contact to wear more...
You can post now ↓↓↓ or ask your question and then register.
If you have an account, sign in nowto post with your account.
Note: Your post will require moderator approval before it will be visible.
Nice to finally meet you tonight. Make sure you tell me who you are again next time you come in. I will probably forget.
Let me know when you are dropping in again and I'll make sure we have more of those beverages around!
This northern boy needs a little help with this one.
Dried up kill hole in the duck timber?
Quicksand that all the deer fell into?
Cool lighting in a forest that’s so different from ours?
I’ve never been in the AR woods before but you’ve arrived by the looks of it.
Good luck.
Question
Lunker
Folks,
Currently planning on swapping out my 12 ft flatbottom for a 14ft flat. Would like to keep my trailer if possible. Currently the trailer extends about 2 inches longer than my 12ft. So if I made the switch it would extend close to 2 ft out past the trailer. Would this be okay or would I need to extend out the runners? The only problem I could think is the weight of the motor that much farther back might cause a bit more force causing some point of contact to wear more...
Thanks
Link to comment
Share on other sites
5 answers to this question
Recommended Posts
Join the conversation
You can post now ↓↓↓ or ask your question and then register. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.