Intermediate spline shaft for 2004 Silverado

[Hookmaster]

I had the dealer relube it 2 times under warranty and I have done it once. It's time to do it again but I might as well replace it. I heard GM has a different design and so does NAPA. Do they solve the problem?

[Macgyver55]

I assume you mean Intermediate steering shaft. I haven't had any complaints on the ones I've done so far.

[Hookmaster]

That's what I mean. Where did you get the part from? How long have they been in the truck?

[Macgyver55]

I've not had to do my own, but I normally use GM parts when possible but also use Napa parts and have not had problems with either on customer cars.

[jwhjr]

I replaced the one in my 04 last fall with the redesigned one and it has been solid. I'll have to look up the part number when I get a chance. I used a GM replacement part through an online site. I posted about it last fall when I did the repair. It's an easy job and you'll be amazed at the difference once the new one is in. It was like I had a new truck. Good luck.

[jwhjr]

Here's the link to my post from last fall - Silverado ISS

Part # used was 19153614

[Jeremy airjer W]

I haven't had any issues with the updated GM part as well.

[TravP]

I need to change mine too. Any tips?

[Hookmaster]

I researched it some. Just make sure to keep your steering wheel from turning during the repair.

[Jeremy airjer W]

Run the seat belt through the steering wheel and then buckle it. Then you'll have no worries about the wheel turning. I've also used black tape sticky side up. Wrap it around the wheel and column a couple of times as it will keep it from turning as well

[caseymcq]

Do they solve the problem?

Most definitely. I had mine done two years ago and have had no more issues... Well no more with that part