Jump to content
  • GUESTS

    If you want access to members only forums on HSO, you will gain access only when you Sign-in or Sign-Up .

    This box will disappear once you are signed in as a member. ?

Propane - rise or sink?


SkunkedAgain

Recommended Posts

Raw fuel and carbon monoxide drops when temps are below 32 degrees. I belive the vent flaps on the top would be to vent out some of the combustion air from your heater. Your heaters produce carbon dioxide while there burning (and hopefully if its running right no carbon monixide), and if there was no venting pulling it out the top then it would fill up the air space inside the house and start using up the fresh oxygen and make you feel alittle sleepy. Even though there is air leaks around the bottom of most portables, having the vents open on top is the safest way. Carbon monixide is deadly, but carbon dioxide can be just as deadly in some situations. Be careful.

Link to comment
Share on other sites

Propane combustion yields 3 by-products: carbon monoxide (CO), oxides of nitrogen, and hydrocarbons. CO is the most dangerous. Since the exhaust is hot, it will rise to the top of the house thus the location of the ventilation flaps. Maintain good ventilation and you should be fine. If worried, buy a CO detector.

Link to comment
Share on other sites

My guess is that it will raise. Logic behind it: The unburned propane will be coming off with the exhaust, therefore it will be at a higher temperature than the ambient air. Since colder air is more dense, the hot exhaust and unburned propane will raise to the top of the ice house.

Link to comment
Share on other sites

If you have raw/unburned propane vapor in your fish house, you have a very explosive problem and need to take a look at your heater before you use it again. I'm serious.

The vents higher up in the air create draft. This draft, for lack of a better word, sucks the CO and CO2 vapors out of the shanty. If they were low to the floor the vapors would collect in the house. Similar, in a way, to how a properly operating smokestack works.

Link to comment
Share on other sites

81Saluki- you beat me too it, but as long as you are listing the byproducts of the combustion of a hydrocarbon, you forgot water and carbon dioxide. In a complete combustion reaction you will have the products of carbon dioxide and water. since a complete combustion reaction is not always the case, you will end up with more, some water, some carbon dioxide(CO2), some carbon monoxide(CO), some unburned hydrocarbons (because of incomplete combustion), and some oxides of nitrogen (this is because air is ~80% nitrogen (N2), because of the high temperatures of a combustion reaction, nitrogen can combine in different amounts with oxygen to form NOx).

sorry for the long rambling, just an extra little tid bit

Link to comment
Share on other sites

Join the conversation

You can post now ↓↓↓ or ask your question and then register. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use and Privacy Policy. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.