Jump to content
  • GUESTS

    If you want access to members only forums on HSO, you will gain access only when you Sign-in or Sign-Up .

    This box will disappear once you are signed in as a member. 😀

  • RECEIVE THE GIFTS MEMBERS SHARE WITH YOU HERE...THEN...CREATE SOMETHING TO ENCHANT OTHERS THAT YOU WANT TO SHARE

    You know what we all love...

    When you enchant people, you fill them with delight and yourself in return. Have Fun!!!

Sign in to follow this  
metrojoe

Heaters 50% off

Recommended Posts

FYI
Stopped by Northern Tool yesterday and they have all or most of their heaters marked down 50% off.

Joe

Share this post


Link to post
Share on other sites

Don't bother checking out the Duluth store, the other retailers bought out their entire inventory. Apparently thats as cheap or better that they can get em through the distributors.

Share this post


Link to post
Share on other sites

Sorry this is a little late had to get an id and password as im new too this board.Thanks for the info.I just started icefishing and bought a colman heater that was way too small, just didnt get hot enough.After reading this post i bought the Mr heat buddy. Big difference,had too strip down too t shirt and still cooked on low .Great deal too i pd $49.99 at the local tractor store for a brand new one . thanks again. and yes i killed the gills caught a few bass and got a dozen crappie my second time out .. im hooked

------------------
ny angler

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  



  • Your Responses - Share & Have Fun :)

    • I’ve never done anything with mine. I store it standing up and in the fall change the oil if I remember. Haven’t had any issues yet. 
    • I had problems with my 02. I found that the plug on the truck side going to the plug at the bumper was corroded. I hope that made sense I cleaned it up and put dielectric grease on it.    
    • I would put some Seafoam in the ga.........................  oh never mind. 😁
    • I rode the trails around big lake today, mostly to get used to the new trails. trails were awesome, they must have groomed last night, rode to becker and back and some other playing around. all in all I put on 42 miles today. I will ride into the orrock area tomorrow. don't ride that much around here anymore, mostly aitkin co. now. looks like the trails around the sand dunes look good, I will give it a shot tomorrow.
    • I'm guessing not much. I know the one pounders threads can start to rust in a humid environment, but am not sure if that would be an issue if still attached? I know nothing about propane augers,  is there an oil tank to keep the engine lubed? And if so, does it need to be refreshed or drained every once in a while? It's not like you need to worry about bad gas gumming up the system.   Mostly,  I'm just replying to give you something to read TJ. Hopefully somebody else will chime in with more knowledge.  
    • Possibility of moisture getting into them after washing the stove top and around the burners? My wife is good at that.
    • I get it, like the woman in the commercial. You are clever. 
    • Fleet Farm currently has Kingsford 15.4lb x 2 for $8.  About the same per pound as the summer sales.
    • We have a 6 year old Frigidare gas range and the ignitors on the top burners seem to be controlled by a ghost.  Sometimes one doesn't work, sometimes another.  Any ideas?   Thanks for your time. Tom
    • Make sure the adapter wiring matches the diagram on the cover of your female plug-in on your truck too.  Some use the center pin for backup lights,  yet others it is an auxiliary.  Also make sure that the lobe on the male is lining up with the lobe on the female plug-in too.
×