Johnson motor

[efgh]

The relays for my tilt and trim on my motor are sticking and will not work every time I want to change the trim, tryed locating a new relay box, but can;t, the motor is a 70h.p.pre 1980 model, any help welcome.

[upnorth]

It may be the switch in the handle (if that is where it is at). I had my tilt fail and I spent 2 days trouble shooting the relays and it turned out to be the switch. You could also try iboats.com, they have some pretty knowledgeable people in their forums.

[Valv]

That is an excellent suggestion (Contact US Regarding This Word), I would think the switch too.

Funny, I just edited the message 3 times...I cannot write "up north" one word, it gives me the Contact Us....what did you do to make the forum "censor" you...up north ?????

[upnorth]

Geez, I must be a bad word around here

Actually that has been going on for quite a while now, it can be a converstion piece on it's own, that and I can rib people about calling me bad names

[JollyT]

I believe "sly ster" also has that problem. The bad word finders built into the software are too broad. Another forum I go to for my other fish hobby (aquariums) uses a replace feature on the bad words. One we have laughed at is the "w" word for a "professional woman". It changes it to "easy girl". Software always amazes me!

[Giant_Jackpot]

I had a similar problem with my 1999 Suzuki. It turned out to be loose connections on the solenoids. On mine there are two nuts on each “post” on the solenoid. I had to take off the outer nut to get to the inner and it was the inner nuts that were loose.

[upnorth]

I think there is a company with the up-north logo and that I believe is the reason for the blockage. Doesn't really matter most people have found away around it.