I have a Strikemaster Lazer 10 Inch power auger. It is about 9-10 years old. I was using it last weekend and the shaft/auger broke in half. I could not believe it.... Is it true I can just buy a new shaft/auger and attach it to my old engine head? Can I attach it to an 8 inch auger instead of the 10 inch? I always hated my 10 inch model. I live in Andover/Blaine, any ideas where I can buy one? Thanks, Joe
I just figured that it is easy enough to just get a 3 bank so when the boat is not in use I can keep all 3 batteries charged. I have not bough a charger yet, maybe I will give it some more thought.
Edit: After thinking this over, with the size, weight, and heat output of the charger (as well as the cost) I think it makes sense to just
buy a 2 bank charger, I have a smaller charger i can use on the starting battery when the boat is sitting at home. Forgive me, for i am a retired engineer and I have to obsess over everything...
Congrats on the motor! I think you’ll like it.
I can’t say much on the charger location but I’ve seen them under the lid in back compartments and under center rod lockers. 160 degrees is more than I expected to hear.
Curious why you’re opting for a 3 bank charger with a 24V trolling motor. Unless you don’t feel you be running you big motor enough to keep that battery up as well?
I did buy an Minnkota Ulterra, thanks for the recommendations. I had a bunch of Cabela"s bucks saved up, which helped. Now i need to
get an onboard battery charger. Where do you guys mount these things in your boat? The manufacturer I am looking at {Noco genius)
says tht their 3-bank charger will run at 160 degrees, seems like a lot of heat in an enclosed compartment? Thanks for any input on this.
Wasn't terrible at a state park beach. Antelope island maybe. I wouldn't recommend it as a beach destination tho. Figured I was there, I'm getting in it.
Question
muskiejoe
I have a Strikemaster Lazer 10 Inch power auger. It is about 9-10 years old. I was using it last weekend and the shaft/auger broke in half. I could not believe it.... Is it true I can just buy a new shaft/auger and attach it to my old engine head? Can I attach it to an 8 inch auger instead of the 10 inch? I always hated my 10 inch model. I live in Andover/Blaine, any ideas where I can buy one? Thanks, Joe
Link to comment
Share on other sites
8 answers to this question
Recommended Posts