- 0
-
Your Responses - Share & Have Fun :)
-
-
-
My kid was eating in Beverly Hills and ran into this guy. Talked to him a bit and wished him luck in the game tonight.
-
🤔as a recovering machinist!🤣🤣that must make me a recovering welder!
-
As a recovering machinist, I can appreciate that. If the spec is 0.001 - 0.0015, then clearly the correct measurement is 0.00125, duh… -
By Crow Hunter · Posted
I just figured that it is easy enough to just get a 3 bank so when the boat is not in use I can keep all 3 batteries charged. I have not bough a charger yet, maybe I will give it some more thought. Edit: After thinking this over, with the size, weight, and heat output of the charger (as well as the cost) I think it makes sense to just buy a 2 bank charger, I have a smaller charger i can use on the starting battery when the boat is sitting at home. Forgive me, for i am a retired engineer and I have to obsess over everything... -
Congrats on the motor! I think you’ll like it. I can’t say much on the charger location but I’ve seen them under the lid in back compartments and under center rod lockers. 160 degrees is more than I expected to hear. Curious why you’re opting for a 3 bank charger with a 24V trolling motor. Unless you don’t feel you be running you big motor enough to keep that battery up as well?
-
By Crow Hunter · Posted
I did buy an Minnkota Ulterra, thanks for the recommendations. I had a bunch of Cabela"s bucks saved up, which helped. Now i need to get an onboard battery charger. Where do you guys mount these things in your boat? The manufacturer I am looking at {Noco genius) says tht their 3-bank charger will run at 160 degrees, seems like a lot of heat in an enclosed compartment? Thanks for any input on this. -
You're very lucky a troop of Sea Monkey's didn't carry you away. -
By bobbymalone · Posted
Wasn't terrible at a state park beach. Antelope island maybe. I wouldn't recommend it as a beach destination tho. Figured I was there, I'm getting in it.
-
-
Topics
-
Question
stick
I have an older Lowrance LMS-480M, and I believe the power button is sticky (bad contacts) and continues to activate. For reference, when I have the button beep volume on, it would beep around every second or so. Since the power button is also the backlight the backlight turns on and off every second or 2 as well. My workaround has been to shut off the volume ans I am ok with it, but at night the backlihht flashing will drive me nuts.
Any ideas on any potential fix?
Link to comment
Share on other sites
3 answers to this question
Recommended Posts
Join the conversation
You can post now ↓↓↓ or ask your question and then register. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.