amateurfishing Posted August 4, 2013 Share Posted August 4, 2013 First time on water this year was memorial day weekend & I finally was able to get the boat wet this am.between this I had a new fuel pump installed to (hopefully) remedy an issue of motor stalling out at higher speeds. Today it would only sit at idle, every time I tried to put it in gear it died/cut out. really peed me off.cable linkage issue? gear issue? dropped it off at shop on way home but am curious as to opinions. just miffed & hope it aint related to new fuel pump Quote Link to comment Share on other sites More sharing options...
kerryd15 Posted August 4, 2013 Share Posted August 4, 2013 Idle set too low? Quote Link to comment Share on other sites More sharing options...
boatfixer Posted August 4, 2013 Share Posted August 4, 2013 Make model and year please. And yes, could definitely be as simple as idle too low Quote Link to comment Share on other sites More sharing options...
delcecchi Posted August 4, 2013 Share Posted August 4, 2013 They still use those interrupter things when shifting? Could that be misadjusted? Quote Link to comment Share on other sites More sharing options...
amateurfishing Posted August 4, 2013 Author Share Posted August 4, 2013 1984 Mercury 75 HP 4 cylinder Quote Link to comment Share on other sites More sharing options...
steamman Posted August 4, 2013 Share Posted August 4, 2013 Just had the same issue with my motor. Would run inidel but as soon as I put it in either fw or rev it would die. The carb was fouled and they had to replace the needle valves. Runs like a champ now. It is a 1987 50hp Merc. Quote Link to comment Share on other sites More sharing options...
amateurfishing Posted August 5, 2013 Author Share Posted August 5, 2013 Just had the same issue with my motor. Would run inidel but as soon as I put it in either fw or rev it would die. The carb was fouled and they had to replace the needle valves. Runs like a champ now. It is a 1987 50hp Merc. cost? Quote Link to comment Share on other sites More sharing options...
steamman Posted August 5, 2013 Share Posted August 5, 2013 $300 for parts, labor and taking boat out on the lake to ensure that everything is fine. All I know is I have the wrong job for what they charge for labor! Quote Link to comment Share on other sites More sharing options...
amateurfishing Posted August 7, 2013 Author Share Posted August 7, 2013 thx steamman, that was it, a needle stuck/gummed up, they just took couple of hours to clean & and good to go. not a horrible bill Quote Link to comment Share on other sites More sharing options...
steamman Posted August 7, 2013 Share Posted August 7, 2013 Good to hear that I could help out and that is all it was. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now ↓↓↓ or ask your question and then register. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.