Trolling motor transducer bracket

[CigarGuy]

Just bought a Elite 7, HDI. What's the best bracket for attaching to bow mounted trolling motor? Anybody have/try the cup looking one? Thanks...

[delcecchi]

The traditional Lowrance one comes with a big hose clamp. I have one but never used it due to awkwardness of having gthe cord going down on a powerdrive minnkota.

[raymondk]

lowrance makes a special one that hugs the bottom of the motor for this transducer but good luck getting one.

[CigarGuy]

lowrance makes a special one that hugs the bottom of the motor for this transducer but good luck getting one.

thats the cup or molded plastic looking one-right?

[Musky_Madness]

Check out transducer saver on oogle

[bturck]

I used the large hose clamp and wire ties to keep it out of the power unit. Fastened the cord all the way up the shaft and kept the last tie loose to allow the cable to slide through from the depth finder when the motor was lowered. 8 years no problems

[CigarGuy]

I used the large hose clamp and wire ties to keep it out of the power unit. Fastened the cord all the way up the shaft and kept the last tie loose to allow the cable to slide through from the depth finder when the motor was lowered. 8 years no problems

That's how I had my 332, wired/mounted. My 332 has a puck style transducer, the Elite had a transom style. I would rather not have it hang down any further than possible. I ordered the Lowrance molded plastic cover for it, that you run a clamp through, similar to the 332. Thanks