- 0
-
Your Responses - Share & Have Fun :)
-
I haven’t done any leaf springs for a long time and I can’t completely see the connections in your pics BUT I I’d be rounding up: PB Blaster, torch, 3 lb hammer, chisel, cut off tool, breaker bar, Jack stands or blocks. This kind of stuff usually isn’t the easiest. I would think you would be able to get at what you need by keeping the house up with Jack stands and getting the pressure off that suspension, then attack the hardware. But again, I don’t feel like I can see everything going on there. -
reviving an old thread due to running into the same issue with the same year of house. not expecting anything from yetti and I already have replacement parts ordered and on the way. I am looking for some input or feedback on how to replace the leaf springs themselves. If I jack the house up and remove the tire, is it possible to pivot the axel assembly low enough to get to the other end of the leaf spring and remove that one bolt? Or do I have to remove the entire pivot arm to get to it? Then I also have to factor in brake wire as well then. What a mess My house is currently an hour away from my home at a relatives, going to go back up and look it over again and try to figure out a game plan. Above pic is with house lowered on ice, the other end of that leaf is what I need to get to. above pic is side that middle bolt broke and bottom 2 leafs fell out here is other side that didnt break but you can see bottom half of leaf already did but atleast bolt is still in there here is hub assembly in my garage with house lowered and tires off when I put new tires on it a couple months ago. hopefully I can raise house high enough that it can drop down far enough and not snap brake cable there so I can get to that other end of the leaf spring. -
-
-
-
-
Bear can relate too. Tell Leech to start a new account named Leech5, we'll know who he is.If he has any trouble, Bear can walk him through it. -
-
-
-
-
Topics
-
Question
Ryan_V
Problem #1, my old, ugly, reliable as heck tractor went belly up yesterday... was putting some equipment away with it and it started to knock pretty bad. shut it off, added a little oil and started it back up again, knocked worse and killed. it is an old Fordson Major, diesel. how much could I get for this for salvage/parts. I don't have much in it, but it has a VERY heavy duty loader with snow wings on it, 3-pt, pto...... this think has always been good to me, is it worth fixing, or should I dump her. problem #2 if I get rid of her, I also now need to sell everything that I had for it and don't know how much they are worth...a 6' brush hog...blade....mckee 8' snowblower. the blower has about $500 worth of a brand new gear box on it. I hate to get rid of all this stuff, I bought it with the hobby farm I bought, but don't want to sink and unreal amount of $ in it either. anyone have any ideas??? I'm a city boy who bought a hobby farm and need a little guidance. Ryan
Link to comment
Share on other sites
1 answer to this question
Recommended Posts