I have a Jiffy Model 30, 3 HP, approx. 3 years old that has a broken "ON/OFF" switch. I can still start the auger no problem but to stop it I have to lay it on its side and pump the gas a little. Not a big deal but I figure I mine as well pick up a new switch and fix it up right.
My question:
Anyone know a store that would stock an "ON/OFF" switch for a Jiffy Model 30 (approx. 3 years old)? Preferrably a store in the northeast metro? Am I better off just trying to order it off the internet? I'd rather just call someplace and swing by and pick it up instead of ordering it.
I just figured that it is easy enough to just get a 3 bank so when the boat is not in use I can keep all 3 batteries charged. I have not bough a charger yet, maybe I will give it some more thought.
Edit: After thinking this over, with the size, weight, and heat output of the charger (as well as the cost) I think it makes sense to just
buy a 2 bank charger, I have a smaller charger i can use on the starting battery when the boat is sitting at home. Forgive me, for i am a retired engineer and I have to obsess over everything...
Congrats on the motor! I think you’ll like it.
I can’t say much on the charger location but I’ve seen them under the lid in back compartments and under center rod lockers. 160 degrees is more than I expected to hear.
Curious why you’re opting for a 3 bank charger with a 24V trolling motor. Unless you don’t feel you be running you big motor enough to keep that battery up as well?
I did buy an Minnkota Ulterra, thanks for the recommendations. I had a bunch of Cabela"s bucks saved up, which helped. Now i need to
get an onboard battery charger. Where do you guys mount these things in your boat? The manufacturer I am looking at {Noco genius)
says tht their 3-bank charger will run at 160 degrees, seems like a lot of heat in an enclosed compartment? Thanks for any input on this.
Wasn't terrible at a state park beach. Antelope island maybe. I wouldn't recommend it as a beach destination tho. Figured I was there, I'm getting in it.
Question
FL SNIPER
I have a Jiffy Model 30, 3 HP, approx. 3 years old that has a broken "ON/OFF" switch. I can still start the auger no problem but to stop it I have to lay it on its side and pump the gas a little. Not a big deal but I figure I mine as well pick up a new switch and fix it up right.
My question:
Anyone know a store that would stock an "ON/OFF" switch for a Jiffy Model 30 (approx. 3 years old)? Preferrably a store in the northeast metro? Am I better off just trying to order it off the internet? I'd rather just call someplace and swing by and pick it up instead of ordering it.
Thanks!
Link to comment
Share on other sites
6 answers to this question
Recommended Posts