I use these to keep my snells tangle-free and easy to find. The 'system' is light, customizable in size and length, and fits into most standard depth plano, flambeau, etc. plastic cases.
1- get some scrap 3/4" inside diameter foam pipe insulation - the black stuff.
2- finish the perforated slit
3- cut to desired length
4- put the loop or swivel end of the snell, leader or rig in the slit
5- wrap line around foam and stab hook in to secure snell.
Now take the $15.00 you saved and put it in the jar marked "New Rod from MidWest".
I just figured that it is easy enough to just get a 3 bank so when the boat is not in use I can keep all 3 batteries charged. I have not bough a charger yet, maybe I will give it some more thought.
Edit: After thinking this over, with the size, weight, and heat output of the charger (as well as the cost) I think it makes sense to just
buy a 2 bank charger, I have a smaller charger i can use on the starting battery when the boat is sitting at home. Forgive me, for i am a retired engineer and I have to obsess over everything...
Congrats on the motor! I think you’ll like it.
I can’t say much on the charger location but I’ve seen them under the lid in back compartments and under center rod lockers. 160 degrees is more than I expected to hear.
Curious why you’re opting for a 3 bank charger with a 24V trolling motor. Unless you don’t feel you be running you big motor enough to keep that battery up as well?
I did buy an Minnkota Ulterra, thanks for the recommendations. I had a bunch of Cabela"s bucks saved up, which helped. Now i need to
get an onboard battery charger. Where do you guys mount these things in your boat? The manufacturer I am looking at {Noco genius)
says tht their 3-bank charger will run at 160 degrees, seems like a lot of heat in an enclosed compartment? Thanks for any input on this.
Wasn't terrible at a state park beach. Antelope island maybe. I wouldn't recommend it as a beach destination tho. Figured I was there, I'm getting in it.
Question
Aquaman01
I use these to keep my snells tangle-free and easy to find. The 'system' is light, customizable in size and length, and fits into most standard depth plano, flambeau, etc. plastic cases.
1- get some scrap 3/4" inside diameter foam pipe insulation - the black stuff.
2- finish the perforated slit
3- cut to desired length
4- put the loop or swivel end of the snell, leader or rig in the slit
5- wrap line around foam and stab hook in to secure snell.
Now take the $15.00 you saved and put it in the jar marked "New Rod from MidWest".
Link to comment
Share on other sites
2 answers to this question
Recommended Posts