I need some advice regarding my 1995 90 hp evinrude. For the past year or so, if you turned the key 10 times, it would just spin 9 times and finally engage and start the 10th time. So, last november, I took it to my mechanic and we lubed the bendix mechanism and this helped temporarily. We then replace the starter and the starting battery. So, my son comes home from college and takes the lund out and tells me it is still spinning?! I will call the mechanic tomorrow but would like any suggestions from you folks in the know. Thanks alot!
I just figured that it is easy enough to just get a 3 bank so when the boat is not in use I can keep all 3 batteries charged. I have not bough a charger yet, maybe I will give it some more thought.
Edit: After thinking this over, with the size, weight, and heat output of the charger (as well as the cost) I think it makes sense to just
buy a 2 bank charger, I have a smaller charger i can use on the starting battery when the boat is sitting at home. Forgive me, for i am a retired engineer and I have to obsess over everything...
Congrats on the motor! I think you’ll like it.
I can’t say much on the charger location but I’ve seen them under the lid in back compartments and under center rod lockers. 160 degrees is more than I expected to hear.
Curious why you’re opting for a 3 bank charger with a 24V trolling motor. Unless you don’t feel you be running you big motor enough to keep that battery up as well?
I did buy an Minnkota Ulterra, thanks for the recommendations. I had a bunch of Cabela"s bucks saved up, which helped. Now i need to
get an onboard battery charger. Where do you guys mount these things in your boat? The manufacturer I am looking at {Noco genius)
says tht their 3-bank charger will run at 160 degrees, seems like a lot of heat in an enclosed compartment? Thanks for any input on this.
Wasn't terrible at a state park beach. Antelope island maybe. I wouldn't recommend it as a beach destination tho. Figured I was there, I'm getting in it.
Question
FOOTDOC
I need some advice regarding my 1995 90 hp evinrude. For the past year or so, if you turned the key 10 times, it would just spin 9 times and finally engage and start the 10th time. So, last november, I took it to my mechanic and we lubed the bendix mechanism and this helped temporarily. We then replace the starter and the starting battery. So, my son comes home from college and takes the lund out and tells me it is still spinning?! I will call the mechanic tomorrow but would like any suggestions from you folks in the know. Thanks alot!
Link to comment
Share on other sites
3 answers to this question
Recommended Posts