dukhnt Posted January 22, 2013 Share Posted January 22, 2013 I just recently returned from a deer hunting trip in SD with my muzzleloader. I did fill my tags but I did have some mis-fires. I would pull the trigger and nothing would happen. When I would cock the hammer again and pull the trigger, it usually went off the 2nd time. After cleaning my muzzleloader when I got home, I notice the end of the spring was sticking out by the hammer. (see photo). I am thinking this is my problem, but wondering if anyone else has had this issue. Or knows what my issue is for sure. Thanks. The hammer is cocked in this photo. You can see the spring sticking out to the left of the firing pin. Quote Link to comment Share on other sites More sharing options...
Gordie Posted January 24, 2013 Share Posted January 24, 2013 My brother- law has the Same gun with the same problem The pin that strikes the primer is dirty, here is what i did to fix it,take screwdriver and push it in until you can get the tip of the screwdriver into those slots and then unscrew the whole pin assembly . Clean pin and spring with some solvent and use a little bore butter on your fingers to lube it up then reinstall. That is a part that should be cleaned after every 5-10 shots IMO.Good LuckGordie Quote Link to comment Share on other sites More sharing options...
dukhnt Posted January 26, 2013 Author Share Posted January 26, 2013 Thanks for the suggestion. I will give that a try. Quote Link to comment Share on other sites More sharing options...
carpshooterdeluxe Posted January 29, 2013 Share Posted January 29, 2013 what model of ML is that? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now ↓↓↓ or ask your question and then register. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.