mr. heater cooker too hot

[icefisherman]

I have a dave genz flip over one man fishouse with no door. When I use my mr. heater cooker to heat it, it gets way too hot in there, even on low. Is there anyway I can regulate it to turn it down any lower using a 1 lb. tank on there. Maybe a regulator of some sort? I think low is like 8000 btu's. I want half that.

[masoct3]

I have the same one. I dont think so, but I will let others finalize that answer. I do know mine is hot on the lowest setting. I actually only use that setting.

[Will]

You could just fish when it's colder out

[WyoChris]

Maybe keep the door open...... or have shorts and a t-shirt on under your warm clothes

[Sherpa]

I believe the guy that goes by esox magnum on this forum said he modified his to be infinitely adjustable. Maybe he can chime in on how he did that and whether or not it will go to a lower setting than a standard heater.

[Esox_Magnum]

Yesmines modified, take the 3 position valve off and toss it, add a hose and regulator and a valve at the heater. I used an old torbo torch dad had laying around the garage, but this was 25 years ago still going strong today.

[icefisherman]

i think I saw this trick on this site but it works really good. Pop off the low,med,high knob and take a screw driver and pop off the little yellow cap on the knob (from the inside). Put the knob back on and you will see a allen screw in there. Fire up the heater, put it to low, put a allen wrench on the screw and turn it I think counter clockwise, and you will see it turn down even lower than the factory setting of low. It seems to work fine but if you go too low than it gets kind of loud. Kind of like when theyre running out of propane.