Tips on starting your new StrikeMaster Auger Powered by SOLO®

[Ed Carlson]

This is the "Official Scoop from StrikeMaster" on this issue guys.

2 issues here.

#1.. Recoil lube is thick and mainly on the Pro 3 HP models...it can be thinned as the procedure recommends.

#2..User error.. Not used to the decompression function on the new Solo's. Please note recommended starting procedure.

Tips on starting your new StrikeMaster Auger Powered by SOLO®

Before starting your new StrikeMaster Auger we recommend these simple steps to ensure proper conditioning of your new auger powered by the legendary German motor SOLO®.

Conditioning Your Recoil

Prior to putting gas in your auger’s power head we recommend (in a warm environment), liberally spray WD-40® on the recoil mechanism as show in the pictures below:

Spray the WD-40® where the recoil rope and the metal guide meet. Again, please liberally spray the WD-40® to ensure it lubricates the whole recoil mechanism. This will ensure your power head performs in the conditions Ice fishermen encounter during the winter.

How to properly start the Solo Engine:

Turn ON/OFF switch to ON.

Prime Engine 5 to 8 times.

Slide the choke lever to start.

Press the decompression button in. Gently and slowly pull recoil rope until resistance is felt, then finish the pull with a short, quick pull.

Note: it is VERY important to find that resistance before pulling cord. That engages all the components properly. This decompression and resistance check must be done before every pull.

Once you hear the engine fire, slide the choke lever to run. Continue the pulling procedure until engine starts.

[lesterl]

I didn't get the picture?