Guests - If You want access to member only forums on HSO. You will gain access only when you sign-in or Sign-Up on HotSpotOutdoors.

It's easy - LOOK UPPER right menu.

Sign in to follow this  
Followers 0
blgoose

new floor in 16ft lund

5 posts in this topic

hello looking for some craftsman to replace my floor and carpet in my 89 16ft lund predator. any one u can recommend.

Share this post


Link to post
Share on other sites

There is a shop in White Bear that does boat rebuilds. But I havn't seen the work they do.

Rob

Share this post


Link to post
Share on other sites

I had that shop in White Bear do some work on my 88 Lund, and they did good work,Stan Berry was the owner, it's just east of 61 on 95, at least I think those are the right road #'s

Share this post


Link to post
Share on other sites

intersection of 61 & 96 East haven't used him but he has been highly recommended

Custom Rigging is his company name

Share this post


Link to post
Share on other sites

I had Stan do some work on an older Lund that I had and was very impressed with the work. And , if you ask him real nice he may give you some fishing tips for Mille Lacs and some local spots. Good luck! Walleyewizard

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  
Followers 0



  • Posts

    • Thanks to Ufatz, I didn't have to make a wasted trip to my mailbox today...
    • YES, they DO shut down if not enough oxygen. Been dealing with that one for almost 15  years of teaching this. They DO NOT have a CO shutoff, that's what I'm trying to hammer into peoples heads. That's what all thermocouples do, shut the gas valve.  A thermocouple is a safety device for some gas appliances. One end of the thermocouple is heated by a pilot flame, and the other end is connected to a gas valve. As long as the pilot light stays lit, the thermocouple holds the gas valve open and lets gas flow to the main burner of the appliance. The sensor on the end of the thermocouple is heated by the flame of the pilot light. The heat generated is converted into micro volts of electricity. This Electricity is enough to open a tiny magnet in the gas valve, and allow the gas to flow. If the pilot light was to blow out, then the sensor on the Thermocouple cools, and then closes the gas valve to the burner. This ensures that when the pilot flame goes out, Gas cannot escape from the pilot. It is automatically shut down.  That's how it works....if there isn't enough O to support the pilot, you might as well hang it up. They've been petitioned to remove their "low oxygen shut off" from their labeling. Best they did was re-word it. 
    • I believe the v-fronts help, but there is always the vacuum on the flat back-end.  I have had both am always surprised by what I'd call the rear drag.
    • Do buddy heaters even have a low oxygen / CO shut off?  My understanding is they have a thermocouple that kills the gas flow if it's not lit, but it will burn as long as there is a pilot light and enough O2 for combustion, which is probably less O2 than what it would take to make you feel like dump.  And even if O2 levels are high, CO can still be off the chart.   Do people get a lot of alarms going off?  Seems like there is going to be CO in my porty just from the buddy heater going even if the conc is well below a danger level.  I figured those things were calibrated for use in places like your house which should be right at about 0ppm, unless it's right next to the furnace.   In a related story, my MIL was house sitting for a friend when the CO detector went off.  She opened some windows and went outside but started getting a headache, naseous, light headed, weak, dizzy, all sorts of symptoms.  Called 911.  Fire department rolled out, ambulance sent.... And the detector was alarming because the battery was almost dead.  CO levels were at 0ppm.    
    • I'll wait patiently on memorial day, veteran's day, the 4th of July, 9/11, Xmas, new years, labor day, or any of the other federally recognized holidays for you to throw up another post with no point.
    • Thinking about building a new Fish House.   Does a "V" Front really make that big of a difference in towing?   Campers aren't "V" front so just wondering. I think I could utilize space a lot better with a regular square front.
    • Did you ever weigh the house?
    • Thanks for the reminder.  The trash goes to the road tonight for tomorrow's pick up.  I'll drag it down the driveway on my way to the lake.    
    • Had to bring the wife back last night anyway but a 3 day run woulda been nice.  I got to play with and feed our granddaughter, get ice gear thawed out and recharge batteries, making lunch and gonna head out for the evening bite.   I have a dream!
    • Thanks Rebelss. You just can't emphasize the importance of a C/O alarm especially with the new fish  houses being built so tight. My service man just ran into a B/O furnace on a no heat after hours call.  Home owner was very lucky and of course no alarm.
  • Our Sponsors