Jim Uran Posted January 26, 2009 Share Posted January 26, 2009 The engine was replaced and bored out to a 4.0 I believe. Anyhow the check engine light has been on ever since than. Pretty much a weekend mechanic job. However, I'd like to get it running again, and get rid of it for cheap. It's a decent looking vehicle and just needs a little TLC, I was told the computer might have to be reprogrammed for the alterations that were done to it. Any truth to this?? Quote Link to comment Share on other sites More sharing options...
Scott K Posted January 26, 2009 Share Posted January 26, 2009 What codes are in it lean? There are some places that will do custom programing to accomidate alterations but its more of a hit and miss, and it can get spendy unless you can have the vehicle there for them to run it then reprogram and retest! Quote Link to comment Share on other sites More sharing options...
Jim Uran Posted January 26, 2009 Author Share Posted January 26, 2009 I hear ya, the knock sensors have been coming up. And it's causing to run kind of rough when it warms up. At start it runs fine. I had it in a local shop and that's what they said is coming up. Quote Link to comment Share on other sites More sharing options...
98prosport Posted January 30, 2009 Share Posted January 30, 2009 see if you can post the actual codes (P0???) we can then give you a direction to go. give the 1st 10 digits of the vin to verify the vehicle. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now ↓↓↓ or ask your question and then register. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.