- 0
-
Your Responses - Share & Have Fun :)
-
reviving an old thread due to running into the same issue with the same year of house. not expecting anything from yetti and I already have replacement parts ordered and on the way. I am looking for some input or feedback on how to replace the leaf springs themselves. If I jack the house up and remove the tire, is it possible to pivot the axel assembly low enough to get to the other end of the leaf spring and remove that one bolt? Or do I have to remove the entire pivot arm to get to it? Then I also have to factor in brake wire as well then. What a mess My house is currently an hour away from my home at a relatives, going to go back up and look it over again and try to figure out a game plan. Above pic is with house lowered on ice, the other end of that leaf is what I need to get to. above pic is side that middle bolt broke and bottom 2 leafs fell out here is other side that didnt break but you can see bottom half of leaf already did but atleast bolt is still in there here is hub assembly in my garage with house lowered and tires off when I put new tires on it a couple months ago. hopefully I can raise house high enough that it can drop down far enough and not snap brake cable there so I can get to that other end of the leaf spring. -
-
-
-
-
Bear can relate too. Tell Leech to start a new account named Leech5, we'll know who he is.If he has any trouble, Bear can walk him through it. -
-
-
-
-
-
Topics
-
Question
krats
I just started thinking about the boat today, maybe I thought that it would warm me up or something. Anyways, I need to replace the material on my splash quards around the outboard and the trolling motor. I think that the guy that I bought the boat from said that it was elevator belting from Mills Fleet. The belting was starting to get pretty stiff last year.
Does anyone have any other recommendations on what type of material I should replace the old stuff with?
Link to comment
Share on other sites
1 answer to this question
Recommended Posts