Jump to content
  • GUESTS

    If you want access to members only forums on HSO, you will gain access only when you Sign-in or Sign-Up .

    This box will disappear once you are signed in as a member. ?

  • 0

Sunflower heater with burst of flame


Woods&Water

Question

I have an older Mr. Heater sunflower heater and new 5# tank. Everytime I use the sunflower, it works fine for just a while then it starts to spit out extra flames above the cage. Could the tank have a bad valve? or could the tank have been purged wrong?

Link to comment
Share on other sites

4 answers to this question

Recommended Posts

  • 0

Is the air mixture hole plugged with a moth or spider web?

If the orifice is plugged it'll burn cold with a flame too.

The orifice is located where the air mixture hole is, you'll have to remove the tube to get at the orifice to clean it. Use a very thin wire.

Link to comment
Share on other sites

  • 0

After the initial purge/fill, it sometimes takes a few more fills to completely purge a tank. My 11 pounder took two or three trys before it settled down. If your 5 pounder is THAT new, it may be something to look into as well as the cleaning for your heater.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.


  • Your Responses - Share & Have Fun :)

    • Wanderer, thanks for your reply. I do intend for it to be 24 volt, with a thrust of 70-80. Spot lock is a must (my wife is looking forward to not being the anchor person any more).  With my old boat we did quite a lot of pulling shad raps and hot n tots, using the trolling motor. Unlikely that we will fish in whitecaps, did plenty of that when I was younger. I also need a wireless remote, not going back to a foot pedal. We do a fair amount of bobber fishing. I don't think I will bother with a depth finder on the trolling motor. I am leaning toward moving my Garmin depth finder from my old boat to the new one, just because I am so used to it and it works well for me. I am 70 years old and kinda set in my ways...
    • Dang, new content and now answers.   First, congrats on the new boat!   My recommendation is to get the most thrust you can in 24V, assuming a boat that size isn’t running 36V.  80 might be tops?  I’m partial to MinnKota.     How do you plan to use the trolling motor is an important question too.     All weather or just nice weather?   Casting a lot or bait dragging?   Bobber or panfish fishing?   Spot lock?  Networked with depth finders?  What brand of depth finders?
    • We have bought a new boat, which we will be picking up this spring. It is an Alumacraft Competitor 165 sport with a 90 horse Yamaha motor. I will be buying and installing a trolling motor,  wondering if I can get some recommendations on what pound thrust I will want for this boat?  Also, I will be selling my old boat, is there a good way to determine the value on an older boat ( mid-80's with a 75 horse 2-stroke  Mariner motor)  I will appreciate any help with these questions.
    • Sketti...  not out of a jar either!
    • Lol yeah I watched that
    • I went ahead and watched some of the MLF coverage.  Wheeler didn’t make the cut but the bigger story was the Poche/Avera fallout.   Kinda funny listening to both sides of the story and putting together the scenario, reading between the lines.
    • Yeah we fished like 6 or 7 lakes down here. 
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use and Privacy Policy. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.