- 0
-
Popular Now
-
- 2,442 replies
- 331,201 views
-
-
Your Responses - Share & Have Fun :)
-
I’ve been givin’ all my local buds grief about those for years. Finally bought some and keep buying it. But I’ve also been trying to cut back on beer drinkin’ to lean out this dad bad a little, this qualifies I figger. -
-
-
-
-
-
-
My kid was eating in Beverly Hills and ran into this guy. Talked to him a bit and wished him luck in the game tonight.
-
🤔as a recovering machinist!🤣🤣that must make me a recovering welder!
-
As a recovering machinist, I can appreciate that. If the spec is 0.001 - 0.0015, then clearly the correct measurement is 0.00125, duh…
-
-
Topics
-
Question
Guest
Hello,
I hope someone here can help me. I have a 1999 Mercury 175 EFI on a Crestliner 21' Phantom. When idling in gear I have to trim the motor up to get the exhaust port out of the water, or else it will start building up pressure and foul the plugs. Not a big deal but I saw another boat with what looked like an exhaust snorkel on it. It attached to the motor and then angled up 4 or 5 inches so the exhaust could exit above the water level without trimming the motor. Anyone know what this accessory is called or where to get it? Any help would be appreciated.
Thanks,
David
[This message has been edited by ncg (edited 05-20-2003).]
Link to comment
Share on other sites
0 answers to this question
Recommended Posts