Strikemaster auger pitch

[kerryd15]

Put on new blades and still not cutting quite right. Is there anywhere south of Mankato or west that can check the blade pitch on a lazer shaft?

[otterman91105]

Look on the strikemaster HSOforum and they will tell you where there is a certified stikemaster mech that can look at it.

[kerryd15]

They show quite a few for enginge parts only 2 for auger stuff. Will the engine places look at the blades?

When I look at mine, on one side I can see a gap between the blade and the auger- looking from the sharp edge of the blade straight back between the bolts. On the other side it looks much tighter. I tried to adjust them to match and will give it a try.

[otterman91105]

I would give them a call. With the pitch being off it's going to make the auger cut bad. When the pitch is right you shouldn't have to put much down pressure on the auger of course if the blades are sharp. Last time i had my pitch fixed it was at strikemaster in big lake before they moved, but they said if you lean on the auger it will throw the pitch off.