transmission repair 2001 polaris 2x4?

[redhooks]

Anybody have a clue on parts and labor to fix? Any recommendations on a good mechanic?

Thanks,

[Dave S]

What model?

[redhooks]

325 magnum

[rundrave]

whats wrong with the tranny?

I may be wrong here, but I am trying to recall what that model has etc.

It could be a bit of effort because you have to remove the clutches to remove the tranny. Its not hard, just takes a lot of time and depending on the condition of your clutches you might need a clutch puller if the secondary doesnt just slide off.

I also dont recall if that models rear end is a IRS or SRS and if its shaft drive. the swing arm bushings can be a bit of a pain to remove and re assemble as well but like I said I am not sure if that model has them.

[Dave S]

It looks to be shaft drive with SRA. If it is the transmission that's bad, you might have to raid the savings account.

The cost of parts could range anywhere around $20 to over $1000 to replace the entire transmission with new parts. Depending on what's bad.

Not knowing what the symptoms are, it's hard to say an exact cost. This was a fairly common machine so used parts wouldn't be out of the question.

[redhooks]

I was looking at buying a used one w bad tranny but will probably keep looking for an easier task.

Thanks for the info