Jmeyers Posted March 23, 2011 Share Posted March 23, 2011 Need a new pedal for my Minn Kota power drive...Was wondering if the pedal of a PowerDriveV2 would also work with it? or do i have to get the replacement pedal for the PowerDrive? Quote Link to comment Share on other sites More sharing options...
PerchJerker Posted March 24, 2011 Share Posted March 24, 2011 I think they have different connectors, ie. flat plug vs. round plug. Quote Link to comment Share on other sites More sharing options...
DanM Posted March 24, 2011 Share Posted March 24, 2011 I just replaced the foot pedal on my Power Drive. $70 from Northland marine[note from admin: please read forum policy before posting again. thanks] Quote Link to comment Share on other sites More sharing options...
Wish-I-Were-Fishn Posted March 25, 2011 Share Posted March 25, 2011 No sir they are not interchangeable, however Minn Kota makes a wireless foot pedal that works with a co-pilot system that is like the style of the V2 model pedal. Quote Link to comment Share on other sites More sharing options...
SkunkedAgain Posted March 25, 2011 Share Posted March 25, 2011 Before you get a new pedal, make sure that you've cleaned the old one. Mine was having issues years ago so I thought about replacing it. Then I pulled it apart and cleaned it all real good. I also learned that dunking the foot pedal in the lake every once in a while (it's waterproof) will do wonders for keeping dirt and grit off the contact points.Then again, I don't know what's specifically wrong with your pedal so those suggestions may not work at all. Quote Link to comment Share on other sites More sharing options...
Jmeyers Posted March 27, 2011 Author Share Posted March 27, 2011 Thanks for the help guys... I took it apart to try and fix it and still its didn't work. I've had it for a good 6-7 years now and pretty much beat the [PoorWordUsage] put of it so I just went ahead and replaced it. Works like a champ now, and thanks for the tip about dipping it in the water I didn't know they were completley water proof! Quote Link to comment Share on other sites More sharing options...
bigpike Posted March 29, 2011 Share Posted March 29, 2011 I have a powerdrive that would start and stop. I had to take it apart and put a few pieces of electrical tape underneath the circuit board where the speed slider and on/off switch were. The little plastic tip on the slider was wearing down and not actually making enough contact with the circuit board. I figured this out because I was able to control it with my finger or the slider in my hand with it apart. After doing this it worked like a charm again. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now ↓↓↓ or ask your question and then register. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.