aqua Vu cable wiring

[delcecchi]

The cable on my old aquaview broke at the connector. I would like to re-solder it. Anbody know which wire goes to which pin? I suppose I could trial and error it since there are two wires and two pins but I would rather know ahead of time.

[pureinsanity]

Which connector?

you need to be a bit more specific.

[delcecchi]

Which connector?

you need to be a bit more specific.

The cable from the camera to the monitor has a 4 pin round connector where it connects to the monitor. The inside of the connector is filled with what looks like hot melt glue. The wires broke at the connector just above the top of the glue. I am working on getting the glue out also. I am about to try putting it in the oven at like 175 or so to try to get it out. Or I will try to get another connector. But knowing the connections would be helpful.

Also, it looks like the panel to access the electronics is glued in place. Is that correct?

[spearchucker]

The electronics are probably potted in epoxy to weatherproof then. I doubt you will be able to get it off without tearing everything up.

[upnorth]

If it is epoxy heat will soften it up enough to pull things free.

[delcecchi]

It has a plastic panel. I guess I need to just get that off to see if the stuff inside is potted or not. Of course if I can figure out how to get the connector back on the cable I won't need to get inside the unit.