- 0
-
Your Responses - Share & Have Fun :)
-
By Crow Hunter · Posted
Wanderer, thanks for your reply. I do intend for it to be 24 volt, with a thrust of 70-80. Spot lock is a must (my wife is looking forward to not being the anchor person any more). With my old boat we did quite a lot of pulling shad raps and hot n tots, using the trolling motor. Unlikely that we will fish in whitecaps, did plenty of that when I was younger. I also need a wireless remote, not going back to a foot pedal. We do a fair amount of bobber fishing. I don't think I will bother with a depth finder on the trolling motor. I am leaning toward moving my Garmin depth finder from my old boat to the new one, just because I am so used to it and it works well for me. I am 70 years old and kinda set in my ways... -
Dang, new content and now answers. First, congrats on the new boat! My recommendation is to get the most thrust you can in 24V, assuming a boat that size isn’t running 36V. 80 might be tops? I’m partial to MinnKota. How do you plan to use the trolling motor is an important question too. All weather or just nice weather? Casting a lot or bait dragging? Bobber or panfish fishing? Spot lock? Networked with depth finders? What brand of depth finders? -
-
-
By Crow Hunter · Posted
We have bought a new boat, which we will be picking up this spring. It is an Alumacraft Competitor 165 sport with a 90 horse Yamaha motor. I will be buying and installing a trolling motor, wondering if I can get some recommendations on what pound thrust I will want for this boat? Also, I will be selling my old boat, is there a good way to determine the value on an older boat ( mid-80's with a 75 horse 2-stroke Mariner motor) I will appreciate any help with these questions. -
-
-
-
I went ahead and watched some of the MLF coverage. Wheeler didn’t make the cut but the bigger story was the Poche/Avera fallout. Kinda funny listening to both sides of the story and putting together the scenario, reading between the lines.
-
-
-
Topics
-
Question
pikerliker
I have a Mag 2000 ice auger which I have had for several years and has always worked well for me. Recently I have had some problems with it. For some reason when I start it the auger blade is spinning when it should be in idle. The auger digs into the ice and it kills. I have to lift the auger above the ice quickly to keep it from killing. I have also noticed that when I'm pulling the chord to start it that the auger blade is turning with each pull. I don't remember this happening before. It is also taking more pulls to start and I have to play with the choke settings a lot to get it going. Any ideas as to what is going on or is wrong with it?
Thanks ~piker
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Join the conversation
You can post now ↓↓↓ or ask your question and then register. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.