- 0
-
Your Responses - Share & Have Fun :)
-
I’ve been givin’ all my local buds grief about those for years. Finally bought some and keep buying it. But I’ve also been trying to cut back on beer drinkin’ to lean out this dad bad a little, this qualifies I figger. -
-
-
-
-
-
-
My kid was eating in Beverly Hills and ran into this guy. Talked to him a bit and wished him luck in the game tonight.
-
🤔as a recovering machinist!🤣🤣that must make me a recovering welder!
-
As a recovering machinist, I can appreciate that. If the spec is 0.001 - 0.0015, then clearly the correct measurement is 0.00125, duh…
-
-
Topics
-
Question
Fish&Fowl
I have a 6500C3 that's a couple years old I use for musky fishing. I take it apart fairly often to clean and oil it, but for the first time I took the reel side apart so the gears and everything were exposed. Now I can get it all back together fine, but when you crank on the reel the spool doesn't spin with it. Any information on something I can try or if I just need to take it in is much appreciated!
Link to comment
Share on other sites
1 answer to this question
Recommended Posts