I am trying to replace my impellar on a 92 yamaha 40hp, but the shift linkage is holding it on still. I got rained out so I'll try again tomorrow, my question is do i have to remove the drive shaft in the hood area, behind the carbs? cause that looks a little tricky:) or is it on the outside of the motor somewhere?
Any help would be appreciated thanks!
Oh, anyone know where to buy a new one? without ordering it?
We went to the flats too. I dipped a tire on the rental car onto it just to say I’ve been there,but it was still pretty soft from winter melt. After seeing some moron in a BMW suv get dragged out of the muck I had no intention of repeating his stupidity.
Question
Sheephead Slayer
I am trying to replace my impellar on a 92 yamaha 40hp, but the shift linkage is holding it on still. I got rained out so I'll try again tomorrow, my question is do i have to remove the drive shaft in the hood area, behind the carbs? cause that looks a little tricky:) or is it on the outside of the motor somewhere?
Any help would be appreciated thanks!
Oh, anyone know where to buy a new one? without ordering it?
Thanks,
Kevin
Link to comment
Share on other sites
1 answer to this question
Recommended Posts