Depth Finder Lost Power

[UMC]

I have an Eagle Ultra 2 depth finder that I can't get to turn on. The last couple times I have been out, it has turned off on its own a couple times but I've been able to just turn it back on. On the way back to the ramp the last time it turned off and I haven't been able to get it back on. I replaced the fuse that leads to the battery connections to no avail. Any ideas?

[jeffreyd]

from the manual.

If your unit is not working, or if you need technical help, please use the

followingtroubleshootingsection beforecontacting thefactorycustomer

service department. It may save you the trouble of returning your unit.

Unit won't turn on:

1 . Checkthe power cable's connection at the unit. Also check the wiring.

2. Make certain the power cable is wired properly. The red wire connects

to the positive battery terminal, black to negative or ground.

3. Check the fuse.

4. Measuretheb atteryvoltagea tthe unit's powerconnector. ltshould be

at least 11 volts. If it isn't, the wiring to the unit is defective, the battery

terminals or wiring on the terminals are corroded, or the battery needs

charging.