Gorilla Inc. Recalls EXO-Tech Safety Harness Due to Fall Hazard
WASHINGTON, D.C. - The U.S. Consumer Product Safety Commission, in cooperation with the firm named below, today announced a voluntary recall of the following consumer product. Consumers should stop using recalled products immediately unless otherwise instructed.
Name of Product: EXO-Tech Safety Harness
Units: About 90
Manufacturer: Gorilla Inc., of Flushing, Mich.
Hazard: The webbing of the waist belt on the safety harness is not routed through the lineman’s loop located on the front of the harness near waist level. Since the loops are not properly anchored to the harness webbing but are attached only through stitching not intended to restrain a user during a fall, they that can pull away from the harness when force is applied, leaving the user unrestrained. In addition, the manufacturer of the harness used a previously untested carabiner connector located at the end of the tether at the back of harness, which is the portion of the tether that attaches to the tree.
Incidents/Injuries: No incidents were reported.
Description: This safety harness, used as a fall restraint for hunting, is comprised of two leg straps and two shoulder straps, which connect to a waist belt and padded back support. There is a long, black tether strap at the top rear of the safety harness, which has grey and red accents. The name EXO-Tech is located on the right front shoulder strap and the name Gorilla is located on the left front should strap both in white lettering. Similar to a shirt tag, there is a white manufacturing label on the inside of the back of the harness with the model number 45111 and manufacturing dates, 4/22/2009 or 6/26/2009. These are the only harnesses recalled.
Sold at: Cabelas, Bass Pro and at various sporting goods stores nationwide from May 2009 to August 2009 for about $200.
Manufactured in: Philippines
Remedy: Consumers should immediately stop using the harness and contact Gorilla Inc. to receive a refund.
Consumer Contact: For additional information, contact Gorilla Inc. at (877) 685-7817 between 9 a.m. and 4:30 p.m. ET Monday through Friday or visit the firm’s Web site at www.gorillatreestands.com. Consumers can also write to the firm at Gorilla, Inc., P.O. 378, Flushing, MI., 48433 or 3475 Eastman Drive, Flushing, MI. 48433.
I just figured that it is easy enough to just get a 3 bank so when the boat is not in use I can keep all 3 batteries charged. I have not bough a charger yet, maybe I will give it some more thought.
Edit: After thinking this over, with the size, weight, and heat output of the charger (as well as the cost) I think it makes sense to just
buy a 2 bank charger, I have a smaller charger i can use on the starting battery when the boat is sitting at home. Forgive me, for i am a retired engineer and I have to obsess over everything...
Congrats on the motor! I think you’ll like it.
I can’t say much on the charger location but I’ve seen them under the lid in back compartments and under center rod lockers. 160 degrees is more than I expected to hear.
Curious why you’re opting for a 3 bank charger with a 24V trolling motor. Unless you don’t feel you be running you big motor enough to keep that battery up as well?
I did buy an Minnkota Ulterra, thanks for the recommendations. I had a bunch of Cabela"s bucks saved up, which helped. Now i need to
get an onboard battery charger. Where do you guys mount these things in your boat? The manufacturer I am looking at {Noco genius)
says tht their 3-bank charger will run at 160 degrees, seems like a lot of heat in an enclosed compartment? Thanks for any input on this.
Wasn't terrible at a state park beach. Antelope island maybe. I wouldn't recommend it as a beach destination tho. Figured I was there, I'm getting in it.
Question
tcwin
Here is another recall I received notice on from CPSC. This is for a Safety Harness.
Be safe out there!
--------
FOR IMMEDIATE RELEASE
November 18, 2009
Release # 10-042 Firm's Recall Hotline: (877) 685-7817
CPSC Recall Hotline: (800) 638-2772
CPSC Media Contact: (301) 504-7908
Gorilla Inc. Recalls EXO-Tech Safety Harness Due to Fall Hazard
WASHINGTON, D.C. - The U.S. Consumer Product Safety Commission, in cooperation with the firm named below, today announced a voluntary recall of the following consumer product. Consumers should stop using recalled products immediately unless otherwise instructed.
Name of Product: EXO-Tech Safety Harness
Units: About 90
Manufacturer: Gorilla Inc., of Flushing, Mich.
Hazard: The webbing of the waist belt on the safety harness is not routed through the lineman’s loop located on the front of the harness near waist level. Since the loops are not properly anchored to the harness webbing but are attached only through stitching not intended to restrain a user during a fall, they that can pull away from the harness when force is applied, leaving the user unrestrained. In addition, the manufacturer of the harness used a previously untested carabiner connector located at the end of the tether at the back of harness, which is the portion of the tether that attaches to the tree.
Incidents/Injuries: No incidents were reported.
Description: This safety harness, used as a fall restraint for hunting, is comprised of two leg straps and two shoulder straps, which connect to a waist belt and padded back support. There is a long, black tether strap at the top rear of the safety harness, which has grey and red accents. The name EXO-Tech is located on the right front shoulder strap and the name Gorilla is located on the left front should strap both in white lettering. Similar to a shirt tag, there is a white manufacturing label on the inside of the back of the harness with the model number 45111 and manufacturing dates, 4/22/2009 or 6/26/2009. These are the only harnesses recalled.
Sold at: Cabelas, Bass Pro and at various sporting goods stores nationwide from May 2009 to August 2009 for about $200.
Manufactured in: Philippines
Remedy: Consumers should immediately stop using the harness and contact Gorilla Inc. to receive a refund.
Consumer Contact: For additional information, contact Gorilla Inc. at (877) 685-7817 between 9 a.m. and 4:30 p.m. ET Monday through Friday or visit the firm’s Web site at www.gorillatreestands.com. Consumers can also write to the firm at Gorilla, Inc., P.O. 378, Flushing, MI., 48433 or 3475 Eastman Drive, Flushing, MI. 48433.
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now