I posted this in a different forum then remembered about this forum
I picked up a Danuser post hole digger for my tractor at an auction very cheap compaired to new, with a 9" auger and a 12" auger. The 12" auger is not a danuser, and am having a hard time finding the right blades for it. Can I buy the danuser blades, fill in the bolt holes with a welder and redrill holes so the blades I buy will fit the auger? I went to 6 different farm implement stores and nobody had the blades to fit the auger I have. I know there needs to be a certain angle for these augers to work, but the blades that came off the 12" auger, are darn near the same as the danuser blades, less than a degree or two off from my measurements.
I just figured that it is easy enough to just get a 3 bank so when the boat is not in use I can keep all 3 batteries charged. I have not bough a charger yet, maybe I will give it some more thought.
Edit: After thinking this over, with the size, weight, and heat output of the charger (as well as the cost) I think it makes sense to just
buy a 2 bank charger, I have a smaller charger i can use on the starting battery when the boat is sitting at home. Forgive me, for i am a retired engineer and I have to obsess over everything...
Congrats on the motor! I think you’ll like it.
I can’t say much on the charger location but I’ve seen them under the lid in back compartments and under center rod lockers. 160 degrees is more than I expected to hear.
Curious why you’re opting for a 3 bank charger with a 24V trolling motor. Unless you don’t feel you be running you big motor enough to keep that battery up as well?
I did buy an Minnkota Ulterra, thanks for the recommendations. I had a bunch of Cabela"s bucks saved up, which helped. Now i need to
get an onboard battery charger. Where do you guys mount these things in your boat? The manufacturer I am looking at {Noco genius)
says tht their 3-bank charger will run at 160 degrees, seems like a lot of heat in an enclosed compartment? Thanks for any input on this.
Wasn't terrible at a state park beach. Antelope island maybe. I wouldn't recommend it as a beach destination tho. Figured I was there, I'm getting in it.
Question
Sarpy Creek Boy
I posted this in a different forum then remembered about this forum
I picked up a Danuser post hole digger for my tractor at an auction very cheap compaired to new, with a 9" auger and a 12" auger. The 12" auger is not a danuser, and am having a hard time finding the right blades for it. Can I buy the danuser blades, fill in the bolt holes with a welder and redrill holes so the blades I buy will fit the auger? I went to 6 different farm implement stores and nobody had the blades to fit the auger I have. I know there needs to be a certain angle for these augers to work, but the blades that came off the 12" auger, are darn near the same as the danuser blades, less than a degree or two off from my measurements.
Thanks in advance.....
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now