Livewells

[RangerDog]

I'm looking to install a livewell in a 16ft. Alum boat. I have all of the floor out so I can just about anything. I'm looking for any ideas on the liner,pumps and installation instructions. Do any of you guys have any ideas or can point me in the right direction. Thanks!!!

[RangerDog]

They have the pump and the other hardware, buy not the tank. I have found one place that makes the tank but they want over $100 for it, and it dosen't even look that sturdy.

[musky hunter]

Consider purchasing a plastic cooler for the tank. Various sizes are available and the lid is built in. With fittings that are available at the marine store I think you could easily build an economical live well. Any holes drilled into it for fittings or brackets should be sealed with silicone. To finish the job, you might want to box it in.

[Guest]

I thought I saw the entire kit in a Cabelas catalog.

------------------
<;(((><

[Valv]

I have a couple of livewells that might fit you. They are for Lund boats.
I'm asking $ 15.00 for Gray larger and $ 22.50 for smaller white.

Both have drain tube, white model can be separated for baitwell also.

[This message has been edited by Valv (edited 05-09-2002).]

[RangerDog]

Valv,
What are the dimensions on those tanks and how would I be able to contact you. One of those might just do the trick.

[Valv]

You can email me at [email protected]

White is 36" long x 11 1/2" wide, 11" high (hole size 33 3/4" L x 10 1/2" W).
Gray 46"top width x 18 1/2" top lenght x 12" height

I also have some through hull fittings I'll give you if you need.

I am located just north of Faribault, 40 milese south of MPLS

Val