Jump to content
  • GUESTS

    If you want access to members only forums on HSO, you will gain access only when you Sign-in or Sign-Up .

    This box will disappear once you are signed in as a member. ?

Heater help please.


Boar

Recommended Posts

I have a glo warm three panel inrered heater an the piolet light iis hard to stay on an when it dose it's three inches long, an sometimes the heater gose out, sometimes the heater works great but with a three inch piolet. Sometimes it wont run on one panel, Could it be a regulater? it has a built in one an then I have one that is outside by the tank. Last year it worke just fine with no problems. any info would be great. Thanks boar

Link to comment
Share on other sites

i would try taking the regulator off next to the tank and heat it up too see if any water comes out. sounds to me like the (one of) regulators is froze up.

i was out last weekend and the pilot and flame were both smaller than normal. took the regulator off and heated it up with a sunflower heater and a tablespoon of water came out of the weep hole on the top of the regulator. put it back on and the heater was back to normal. other than that i dont know much about the stove. give it shot may be an easy fix. good luck

Link to comment
Share on other sites

Join the conversation

You can post now ↓↓↓ or ask your question and then register. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use and Privacy Policy. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.