I've got a chance to fix up an older ultra shack drop down fish house that needs to have some framing replaced. Its been 15 or more years since I welded, but I'm willing to get back on that bike.
I'm looking for 3" rectangular tube around 3/16" thick ideally, but would consider 3" channel or angle in a pinch. Would need a couple that are 10 feet long and one or two that are 7 feet long.
I know where to buy new steel stock - what are some places to go root through scrap - do such places exist that are open to the public? And, if they exist, what are my chances at finding these lengths?
I've also thought about buying a couple junk trailers with the right stuff and cutting them down.
I just figured that it is easy enough to just get a 3 bank so when the boat is not in use I can keep all 3 batteries charged. I have not bough a charger yet, maybe I will give it some more thought.
Edit: After thinking this over, with the size, weight, and heat output of the charger (as well as the cost) I think it makes sense to just
buy a 2 bank charger, I have a smaller charger i can use on the starting battery when the boat is sitting at home. Forgive me, for i am a retired engineer and I have to obsess over everything...
Congrats on the motor! I think you’ll like it.
I can’t say much on the charger location but I’ve seen them under the lid in back compartments and under center rod lockers. 160 degrees is more than I expected to hear.
Curious why you’re opting for a 3 bank charger with a 24V trolling motor. Unless you don’t feel you be running you big motor enough to keep that battery up as well?
I did buy an Minnkota Ulterra, thanks for the recommendations. I had a bunch of Cabela"s bucks saved up, which helped. Now i need to
get an onboard battery charger. Where do you guys mount these things in your boat? The manufacturer I am looking at {Noco genius)
says tht their 3-bank charger will run at 160 degrees, seems like a lot of heat in an enclosed compartment? Thanks for any input on this.
Wasn't terrible at a state park beach. Antelope island maybe. I wouldn't recommend it as a beach destination tho. Figured I was there, I'm getting in it.
Question
federline
I've got a chance to fix up an older ultra shack drop down fish house that needs to have some framing replaced. Its been 15 or more years since I welded, but I'm willing to get back on that bike.
I'm looking for 3" rectangular tube around 3/16" thick ideally, but would consider 3" channel or angle in a pinch. Would need a couple that are 10 feet long and one or two that are 7 feet long.
I know where to buy new steel stock - what are some places to go root through scrap - do such places exist that are open to the public? And, if they exist, what are my chances at finding these lengths?
I've also thought about buying a couple junk trailers with the right stuff and cutting them down.
What do you think? Thanks for any help...
Link to comment
Share on other sites
2 answers to this question
Recommended Posts