Eagle Cuda 300 Question

[Born2Fish]

Ok I have a Cuda 300 fish finder. It is fairly new. My problem with it is, when I turn it on it goes straight to the simulation screen. Now it is supposed to save all prior input and not do this. Plus it reads 755 feet in 3 feet of water(actually it reads huge depths all the time). We had gotten one prior to this and it did the same thing. This new one worked for a while, and now all the sudden just started this. It also will not show bottom. Could this be a wiring problem? Could it be a transducer problem? We have tried the master reset with no success. Does anyone have any idea how to fix or what to try?

[PerchJerker]

Sounds to me like the problem is with the unit itself, since it goes to sim mode every time you power it up. I wouldn't mess with the wiring or transducer until you get that part of the problem taken care of.

[Born2Fish]

That is just the thing. I have done everything I know how to do, to get this to work. I was also thinking it could just be the unit, because the first one we got did the same thing. Any suggestions on where to start with the unit? Like I said we have used the master reset a couple times. Or could this just be a bad line of fish finders?