Quantum Smoke 151 Cleaning Oops

[jalberg]

Took apart a Quantum Smoke 151 to clean it. I had just finished cleaning two other Lews reels without any problem. I cleaned the Smoke 151 and put it back together then looked down at the table to see two very small washers laying there. I have no idea what part of the reel they came from. I looked up the schematic online and they don't seem to be on there. It seems to work fine, but I don't want to use it with parts missing. I know the washers didn't come out of the Lews reels and they weren't there before I started. I took apart a Smoke 101 and that reel doesn't have the washers. I don't own another 151.

I guess my question is does anybody know were they go or how I can figure it out?

[CAMAN]

The schematic I'm looking at has a washer on each side of the level wind worm shaft. (12 & 25)

http://www.tackleservice.com/bps/zebco/tackleservice/knowledge/sl151hpt%20schematic.pdf

Otherwise if they're slightly larger I would say they are part of the ones on the handle shaft (63, 65 & 66)

[jalberg]

Thanks for the help, thats the same schematic I was looking at. They are actually smaller than that. They are more like the size of the E-clips, 11 & 27 but they are washers. I know the Lews reels dont have them as I just finished cleaning 2 more and the smoke 101's dont have them either. They wouldn't have been there before I started because I was using the dining room table, so they had to be from the smoke 151. I have no idea...

[CAMAN]

Check if you are missing anything where 14C is supposed to be

[jalberg]

I will check that. I just noticed 58, 59 & 60. Those could possibly be it too.

[CAMAN]

Only if you disassembled the entire spool tension knob.