Using a Fluke Meter

[chasineyes]

Seem to be experience a brain fart...when I OHM a motor, should there be any "movement" in the numbers. I have a bad window motor I think, I have 12 volts to the motor from the switches but nothing is happening with the motor. When I ohm the motor out, my numbers move all over the screen. I'm guessing this is not normal??

Thanks

[Jeremy airjer W]

You would be correct. It is not normal. Make sure only one of the wires has power to it in the up position and the other in the down position. I like to stick the probes in the connector and do the test above. That way I can make sure it is grounding at the same time.

Usually you can whack the motor with the switch in either position and get it to work.