DCON Posted September 4, 2004 Share Posted September 4, 2004 Just picked up my empire direct vent 25k btu and am going to be installing it this weekend. Anyone have any tips? the directions seem fair but rather complicated. Anyone have any definate do's or dont's? Link to comment Share on other sites More sharing options...
Tahoe2349 Posted September 4, 2004 Share Posted September 4, 2004 Dcon you must be heating up a small building with that 25,000 lolIf you are building the house and have a kitchenette planed with counter top, stove and such, install under or within that configuration.. I'm guessing the house is of large size for that model btu.Keep as low to the ground as recommended and thermostat not near unit or higher than mid wall.I have a 14' with a rear kitchenette that runs the width of the house where my 10,000 is mounted under it in the corner.Its secluded and exhausted right out the rear of the house and wastes no space or in the way of traffic within the house..We always incorporate our heaters in to cabinets or counters close to the floor. better security and better floor heat.One of my Dads houses has a 6' closet in it withe Empire in the lower half of it. Link to comment Share on other sites More sharing options...
Recommended Posts