We recently purchased a fish house that we are trying to finish up before we put it into strorage for a very long 9 months or so.
My question : How do you run your LP line out of your fish house short of just drilling a hole and feeding it through? Do they make an insert or something that will make it look clean and protect the hole from being cut on the steel siding?
I went ahead and watched some of the MLF coverage. Wheeler didn’t make the cut but the bigger story was the Poche/Avera fallout.
Kinda funny listening to both sides of the story and putting together the scenario, reading between the lines.
got this tackled today took about 3 hours to get both sides done. Didnt even get to use a torch....
Thought I was golden with just jacking it up and I could get to everything but no luck. Had to remove the entire axle hub and brake assembly to get to what I needed. Was a pain but still better then taking off the entire pivot arm.
Axle bearings were already greased and in great shape thankfully. Got both leaf springs installed and its ready for the road again.
Probably going to have my electric brakes checked, I am not touching anything with the brake drums. Based on what I saw it doesn't look like my electric brakes have been working anyway. Brakes are nice to have if its slippery out
Question
woody1975
We recently purchased a fish house that we are trying to finish up before we put it into strorage for a very long 9 months or so.
My question : How do you run your LP line out of your fish house short of just drilling a hole and feeding it through? Do they make an insert or something that will make it look clean and protect the hole from being cut on the steel siding?
Any help is appreciated.
DL
Link to comment
Share on other sites
1 answer to this question
Recommended Posts