Jump to content
  • GUESTS

    If you want access to members only forums on HSO, you will gain access only when you Sign-in or Sign-Up .

    This box will disappear once you are signed in as a member. ?

Placement of propane tanks


schl0430

Recommended Posts

Quick questions for all of you who have fish houses. I'm building a fish house and I was planning on mounting my propane tanks inside of the house. They would be in a cabinet up front that would be insulated and then have a vent cut in the side to allow air in from the outside. Is this recommended or should the tanks be mounted outside. I've heard conflicting stories and just wondering if anyone else has there tanks mounted inside. Thanks.

Link to comment
Share on other sites

I totally agree, put them outside. You could not put a big enough vent in to make that safe.

Haveing them inside is just not safe, and I have not figured out the advantage of keeping them inside.

Federal and State RV code requires exteral mounting of all propane tanks.

Link to comment
Share on other sites

Related question...My heater and stove will be about 7 feet from the front of my trailer. Should I mount my tanks in front and run a gas line 7+ feet or should I just run a line out the side of the shack and place the tanks there. In the 2nd scenerio I would only have to run the lines a foot or so. I have 2 30# tanks.

Link to comment
Share on other sites

I will mount outside, thanks everyone. Hopefully I can post some pictures of my house on here someday, I'm in the process of building a 19' house, 8 holes, should sleep 4, oven/stove, and other accessories. Been reading posts on here and they have been very helpful, thanks everyone for the tips, now I just have to figure out how to post pictures. Thanks again.

Link to comment
Share on other sites

430 Hello,Im not sure how big your house is going to be but put pulls on both sides of your house.If your making a pull behind portable put the tanks between the front of house and tow vehicle.(If your rear ended on the road it may end up looking like something from iraq)jmtc..c63

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.


  • Your Responses - Share & Have Fun :)

    • Bighorn sheep at Lemoille canyon.   
    • Wild horses in Sparks Nevada   ad
    • Donner lake near Donner pass in California   
    • Redwoods near Big Sur California.  
    • Power output is:  amps x volts = watts   If your charger is pushing 10amp at 12 volt: 12 x 10 = 120 watts.  2 banks = 240 watts.   240 watts / 120v at your outlet = 2 amp.   Efficiency isn't 100% so it's gonna be more than 2 amp on your garage circuit, but maybe like 2.4 amps.     I think.... It's been a while, LOL.  Either way 20amps output on a charger for a 12v battery isn't the same as pulling 20amps off your garage circuit.
    • Wanderer, thank you. I did look at the breakers for my garage/outside outlets and they are 20 amp.  I reached out to the company that makes dual pro chargers with the question and this is the reply I received.:     Thank you for reaching out to us here at PCS. The Sportsman series charger, although rated ay 10 amps per bank, draws only 5 amps from AC when all banks are charging. As the Professional series which provides 15 amps per bank, has a maximum AC draw of 7.5 amps with all banks charging.  
    • That’s an interesting point.  While I understand how Amps work, I can’t say I’m fully versed in the draw of modern on board chargers.   By modern code, outdoor and outbuilding outlets should be 20 Amp.  If your outside or garage outlets are 15 Amp, they’re undersized.  But that is quite possible if the garage was built before that code became enforced.   With heavy use, you may not be able to keep up on daily charging without the 10 Amp per channel charger, however that’s with very aggressive use for consecutive days.  On our June muskie trip we run up to 15 hours a day for up to 7 days on a 24V Ulterra and by mid week we’re starting to see the batteries not reach full charge.  That’s a lot of bank running at nearly 2 mph on windy shores.   We charge at a dock with up to 6 boats per dock plugged in - some with 36 volt systems.  Now I’m not sure if all the outlets are on a dedicated circuit but I’m betting they aren’t.  But they’re all 20A outlets with a lot of draw on them.  At max draw, they’re not keeping up but also not tripping the breakers.   What I’m saying, without a technical review is: you’re probably fine either way.  You probably won’t tax your batteries so much that they can’t recover on a 5 Amp per channel overnight charge and a 10Amp per channel charger probably won’t be too much to plug into your 15A outlet - if it really is a 15A.  If you’re sure, you’re sure, but I would double check if you’re not 100%.
    • Another question- I wil be running 24 volts on the trolling motor for this boat, what amperage onboard charger should I buy? Some have told me 10 amps per channel, but at full draw that would be 20 amps, and my outlets at home and where I plug in at the lake is only 15 amps, is 5 amps per channel enough to charge batteries overnite after using spotlock during the day? Thanks for the help.
    • Got a look at a condor yesterday at Pinacles national park. This was the best I could zoom with my phone.  
  • Topics

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use and Privacy Policy. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.