- 0
-
Your Responses - Share & Have Fun :)
-
I’ve been givin’ all my local buds grief about those for years. Finally bought some and keep buying it. But I’ve also been trying to cut back on beer drinkin’ to lean out this dad bad a little, this qualifies I figger. -
-
-
-
-
-
-
My kid was eating in Beverly Hills and ran into this guy. Talked to him a bit and wished him luck in the game tonight.
-
🤔as a recovering machinist!🤣🤣that must make me a recovering welder!
-
As a recovering machinist, I can appreciate that. If the spec is 0.001 - 0.0015, then clearly the correct measurement is 0.00125, duh…
-
-
Topics
-
Question
danny berg
Made a trip to Strikemaster yesterday to get some needed parts. All I can say is Cy and the guys there are the best. I was so happy with the service I decides to buy a new drill for the magnum III, I went with the 8" 2 blade lazer drill. I never knew what a differece the blades made. I have never drilled a hole so fast, what a difference from the chipper blade.
Oh yah, if any of you are looking for an exhaust extention, Strikemaster has about 9 or 10 left in their wareehouse.
Link to comment
Share on other sites
0 answers to this question
Recommended Posts