Jump to content
  • GUESTS

    If you want access to members only forums on HSO, you will gain access only when you Sign-in or Sign-Up .

    This box will disappear once you are signed in as a member. 😀

  • RECEIVE THE GIFTS MEMBERS SHARE WITH YOU HERE...THEN...CREATE SOMETHING TO ENCHANT OTHERS THAT YOU WANT TO SHARE

    You know what we all love...

    When you enchant people, you fill them with delight and yourself in return. Have Fun!!!

Sunset Lodge

2.18.19 Sunset Lodge Fishing Report, Nw Angle Of Low

Recommended Posts

Hello from the NW Angle!

Minnesota walleye are being caught at a variety of depths with 24-27’ being the most consistent. Glow red with gold has been a hot combo this week. Rattle baits continue to draw active fish to our houses. Sauger activity has been very strong, providing Anglers the opportunity for full limits before new regulations take effect on March 1st. New limit regulations give a combination of six walleye/sauger with no more than 4 walleye. The slot of 19.5”-28 must be immediately release with one walleye over 28’ to be allowed in possession.

Canadian crappies are still filling buckets and freezers, they can be found near the bottom in 32-35ft. Super light tackle and willingness to keep trying different jig combinations is producing the most fish.  Many tulibee are being seen this week, which make for a tasty treat out of the smoker.  Walleye fishing continues to be very good in traditional areas, depth at 23-28ft. 

Snow depth in our areas is between 2 and 2.5 ft. Trails are in great condition after last weeks snow and wind conditions. 

Until next week, 
Sunset Lodge

51745122_2073932622690175_2740901154526330880_o.jpg

52093998_2073932709356833_3395678037017100288_o.jpg

52480815_2073932526023518_8422353974656499712_o.jpg

asd.jpg

IMG_3087.jpg

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.




  • Your Responses - Share & Have Fun :)

    • Lead acid battery discharge is voltage related not amp/current. Amp hours are time based on about a 15% drop in voltage which is the same voltage where a DC motor stops turning. 12v battery flat volts is about 10.5v & 36v battery at 30v & motors stop turning. If you don't turn the motor switch off, discharge will continue down to 0 volts but battery will recover when re-charged. Not good for the battery to drop volts to 0v as it reduces the life of the battery. Lead acid discharge rate chart showing volt loss.
    • Just one of those games where we didn't get the bounces to go our way like earlier in the season. So.........win the next two games, get absolutely crushed by Ohio State and then head to the Rose Bowl. I can live with that.  
    • All you guys still don't get it.   I didn't explain it well enough.    There are three batteries, each can hold 80 Amp hours.      When the 24 volt motor is in use, two of the batteries use some of their capacity, equal for each battery.   So let's say you use 10 amps for two hours.   Now you have two batteries with 60 and one with 80.   Run all three (36 volt motor) for 6 hours at 10 and two batteries will be totally discharged and one will still have some charge.   Any further current draw will potentially damage the two batteries that are totally discharged.      Of course the 36 volt motor will probably quit working as soon as two of the batteries are flat, but the concern is there.
    • pulled the sled out, turned the key after putting in fresh gas, and it fired up spot on. seems to want to go, as it jumped at a little throttle, bring on the snow, its ready.
    • Del is correct 3ea 12v batteries in series are required to get 36v. 2 in series to get 24v and each battery 12v. You can connect a + and - wire to each individual battery, while wired in series, and run 3 separate 12v isolated devices. A + and - to either of 2 in series gives you 24v.   You NEED a "3 bank marine charger" which has 3+ and 3- charging wires which charges the 3 batteries independent of each battery. When one battery reaches full charge, that bank shuts off other 2 banks continue to charge until respective batteries are fully charged. Batteries will not overcharge.    You can run both 36v and 24v motors on a 3 in series batteries but DON'T run both at the same time. Current draw on the 2 24v batteries will greatly reduce battery life and under serve current on the 36v motor.   Best solution is separate battery banks and chargers for each motor and a separate 12v for starting motor and running 12v electronics.    Suggestion, carry a set of jumper cables long enough to reach from the battery bank to your primary motor battery. If your starter battery dies 5 miles off shore, just jumper to any one of the trolling motor batteries to start your engine.
    • Well that game went about as expected. Was worse for me, because my directv went out, so I had to listen to the game. Couple plays I wish they would have done differently...go for the touchdown at the end of the first half, instead of field goal. And when it was 4th down midway through the 4th quarter, they should have kicked the field goal instead of going for it. Was fun having a top ten ranking while it lasted. That loss guaranteed gameday won’t be here for Wisconsin game.
×
×
  • Create New...