- 0
-
Your Responses - Share & Have Fun :)
-
-
I'll try it again. On display and did not want to get off the side of the road! -
-
-
-
-
On display and did not want to get off the side of the road.
-
No, it is the underside of a bridge, but it does kind of look like an aqueduct.
-
They’re cool… right up until they wipe out a good panfish population.
-
-
-
Topics
-
Question
DGTAYLO
I have a Lowrance LCX-15MT mounted on my dash that is having an issue but a little background may be needed. Recently my sonar depth would read correctly and then start flashing as if it was not finding bottom. This was happening at speed or just floating. I made sure the connections were tight, which they were. I took my front sonar and plugged it into the dash cables and it also had the flashing issue. I had a new transducer for my front lowrance (different model) that I was not using. Hooked the new one up and it worked fine. I then removed the old cable and installed the new one. I attached the Y adaptor to both the transducer and the Speed/Temp cable. The sonar is now functioning perfectly. Now when powering the X15MT on or disconnecting and reconnecting the Sonar cable the Temp reading is accurate for 6-10 seconds. After that the Temp went back to 32 and started flashing. I can replace the Y adaptor cable but thought someone else may have had the same issue. Any ideas suggestions would be appreciated.
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Join the conversation
You can post now ↓↓↓ or ask your question and then register. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.