flasher interference-setup

[kapp]

when using multiple vexilars and marcums in the same house what is seams to work best to limit interference? Is it best to turn on Marcums first and adjust the Vexilars to them of vice versa? Or maybe there is other tricks. Any thought or experiences helpful.

[PerchJerker]

Try to have your transducer above the bottom of the hole a bit if possible, you will pick up more interference if your transducer hangs out the bottom of hole (below the bottom of the ice).

Run the units on the narrow beam setting.

It works best to adjust 1 unit at a time --- get one working, then move on to the next, then the next, etc. If you try adjusting multiple units at the same time you're probably heading for unneeded frustration. My opinion would be to clean up the Marcums first --- they have the best interference rejection and will be the easiest to clean up --- then move on to the Vexs. But you still need to get them all cleaned up anyway so it really doesn't matter where you start and where you end ..... just tackle them one at a time.

Good luck, hope that helps.

[CaptainMusky]

Jerker has it spot on based on what I have experienced. Though, if you have an LX5 in the bunch, it could be a LONG day of frustration for the Vex crew.