Jump to content

pj4

we are 'the leading edge' I Share on HSO
  • Content Count

    237
  • Joined

  • Last visited

    Never

About pj4

  • Rank
    Sr IceLeaders.com Family
  • Birthday 10/04/1960

Profile Information

  • Location:
    MN.
  1. we are heading out friday also, staying at jacks. our first time to the area. looking so forward to this. thanks for all the info, been a big help. think we will boost the lines to 20 lbs, have some young kids and few new to fishing. what channel do people use there to share info?
  2. thanks for all the info!! our rods are set with 15 lbs line from lake superior, is that heavy enought for lake michigan?
  3. heading to washington island, july 31 till august 4. new to the area . looking for fishing reports there and any advice on tackle,fishing hours, night life,resturants. thanks for any help.
  4. pj4

    briaded line

    had the same problem last year. was a sharp spot on the eyelet. it was nicking the line. lost several lures before i found it.
  5. pj4

    salvage worth

    look into the new gov. rebate coming out soon. 3500.00 or 4500.00 in rebate for that truck towards a new one. dealers are supose to scrape truck after. it has to have insurance on it during the last year. just wish it could go towards a newer used one.
  6. code 135 came up. E&C data line failure with heater and a/c control assembly. would that be a wire to control unit?possibly loose?
  7. sent my e-mail to you, thanks.
  8. i have an 07 can-am 800 efi.saw some aftermarket injection curve controllers. any one have any experience with these units? there is many different brands and type of units. just looking to up the low end power alittle for playing around. tried 30" mudlite xxl tires and lost too much on the low end. by the way, the 30" tires fit with no mods required. going to put a spring in the clutch to help raise the engagement rpm. be fun to crank up the power.
  9. i spent some time searching for a self test or more info on testing the atc, did not find anything of help.
  10. you might be right about the ground or wiring, the problem is intermitten. any ides where the ground wire for that would be? i did not find a fuse for the atc to follow the wire and check connections. there is a bunch of relays and fuse's under the hood just below the windsheild.
  11. have a '92' olds ninety eight, 3.8, with automatic electronic climate control. lately when starting the car the panel has three lines across it and the fans blows at high speed. during this time i can not change the settings. if i kill the power(turn key off) and restart, sometimes it will preform normaly. any ideas where to start looking for the cause?
  12. pj4

    pantera no starrt

    the battery is fully charged, tried moving the throttle and still no spark. how do you test the throttle position sensor? it has three wires, using an ohm meter and watching for a change in resistance as the sensor moves? just hoping its not the ecm. the kids are bugging me to get it running for them, i feel so bad for knowing so little about artic cat wiring.how does a person test the ignition timing sensor? thanks for any help.
  13. pj4

    which oil

    its the 04 and new ski-doo that need the sythentic or blend oils. the older units have very little problem with ski-doo mineral oil. as for the cheaper brands, you might have problems if it create more ash then oem oil.
  14. pj4

    pantera no starrt

    i have a 95 pantera with 583 efi. the sled started after several tries this fall, ran for 10 min. stumbled once then i shut it off. now it wont start again,no spark. tried new cdi box, no hlp. looking for wiring skimatic for the coils, cdi,ect. not sure how to check each componet,. the coil has continuity. was think its a broken or loose wire, found nothing. this sled ran flawless for years.
  15. pj4

    Froze down flooded wheel house

    i agree, do not use a gun to crack the ice. too many things can go wrong. imagine explaining to the sherrif why your buddy has a hole in the forehead from the recqocet of the ice!! been thinking of a design where a person can use a weed burner in the end of your frame to blow heat through out the frame for thawing out ice. one corner turned up with cap to add heat, opposit corner has outlet. just a thought!
×